So glad to see a real roofer doing a proper cut valley. So tired of seeing the lazy wont to bee's doing point out cheesey valleys. 😅😅
@billspeight893611 ай бұрын
Thanks great video and informative
@digitalcynicism2 жыл бұрын
Lol the whole reason I was watching was to see when you cut it and then the video ends
@ilyaschool2 жыл бұрын
Right
@timg31693 жыл бұрын
Good video but your fly is noticeably down at time marker 3:18 to 3:28. You forgot to zip after taking the tinkle.
@markhenry66223 жыл бұрын
Lotta negative comments but I'm willing to bet it'll last just fine.
@filippkharinpolice2 жыл бұрын
Yea most likely people that never roofed🤣
@johnd95414 жыл бұрын
True roofing pros use open metal valleys, especially with laminated shingles. Bending shingles to conform to a valley weakens them or causes bridging. Never skimp on valleys to save money or time.
@prodig16283 жыл бұрын
Start the bottom as straight as possible follow that shingle keep a 5 5/8 difference in your pattern all the way up the lowest point and your bleeder will run a half inch away straight up and down the valley which ever point is higher ,waste of material the way he's doing it if you start the valley and work your way out you follow the papers lines not too hard yes push down in the middle don't listen to that comment
@samho9318 Жыл бұрын
Not enough detail, sorry. Appreciate the time though.
@arthurrivera42305 жыл бұрын
Can’t see shit!!
@albertstrong55163 жыл бұрын
You need to start the video from the start of the starter strip. And were is the roll of shingles going up the side. Didn't enjoy the video. I give it a C- at best.
@larrycrookshanks90913 жыл бұрын
Ditto John D. Only idiots don't have a clue as to how to install metal valleys .
@JJ_52894 ай бұрын
You started the video halfway up the valley. Not helpful
@NotYou-ho3mm3 жыл бұрын
You forgot to add shingles down the middle of the valley