This video shows you how to start the new STIHL MS500I
Пікірлер: 9
@em4703 Жыл бұрын
You only need to pump the primer when the saw is cold and you want to start it. It take hours for the pressure to drop below the minimum 2 bars inside the injector lines for this to be required again, so if you stop the saw for a few minutes, you don't need to pump the primer again. Pumping the primer after every restart is a waste of time, you're just circulating fuel around and that's it. Also, you can start it between your legs like any other saw, no need to put it down in the mud, it's in the manual. Nothing is worse than giving half assed advice, just read the manual and watch the fuel injection system diagram to understand how it works, only then tell people what's what..
@robertodebeers2551 Жыл бұрын
Thank you.
@robertodebeers2551 Жыл бұрын
Outstanding. Thank you.
@onthelake9554 Жыл бұрын
Show of hands : how many people buying 500i's set their saw on the ground to start it ? = none
@alanmeyers3957 Жыл бұрын
And how many use the decomp? None.
@adrianstefan23 Жыл бұрын
🔊🔊👏🏻👏🏻
@viciousKev Жыл бұрын
Okay.
@lkjyuiop1987 Жыл бұрын
I like the ms462c better
@Logan-fs5wg22 күн бұрын
Bring back o series saws man this new stuff is garbage