How to Test a Stator on an Outboard Motor | Outboard Stator Test | Boats.net

[@nygardenguru]

Makes perfect simple sense check the three phase AC voltage output before it goes into the rectifier

[@mitchelldranow5069]

Did you start the motor with wires from the stator connected to the rectifier and then unplug that connection and test the voltage, or did/could you start the motor without the stator wires being connected to the rectifier?

[@jackcoveproductions]

you can start without as its controlling just the charging system and not the ignition system

[@disneydaddy9967]

John, would the stator malfunction under a load? I can't get my boat to go full speed and I've replaced or repaired everything having to do with the fuel system. It will idle fast and throttle full if I pull it out of the water, but with a load, Turtle speed. Yes my prop is new as well. Bought it all from you guys 😂

[@Rosco3546]

Is it ok if the voltage goes up to 70 volts on a high rpm

[@Thecoachco]

I can't even get my connection apart,its almost as if someone used crazy glue to connect,you took yours apart so easy,Im wondering if mine is melted together,,is it okay to spray penetrating oil ?

[@fisherofmen9941]

Is that a DVA voltmeter? If so, shouldn't the setting be on DC?

[@jackcoveproductions]

no yellow wires are A/c volts.........and hes using a multimeter which can do multiple settings hence the name......

[@cristopheramorin9011]

Sir hope you help me to learn about outboard engine specially electrical system.thanks

[@fisherofmen9941]

What role does the stator play in outboard ignition? My 92 Johnson 60hp won't crank. I've replaced power pack, plugs and fuel pump. Can the stator cause no spark when attempting to crank the motor?

[@fishinmagician3960]

Did you replace ignition coils when you did the power pack? That could be your problem.

[@scotribolla5381]

Thanks for the great video. If it's bad and doesn't crank I suppose step 2 is difficult.

[@coop6425]

What If you read a 1.11 from 1 to 3? I have a 2004 yamaha 115 4 stroke. The others are reading .55 and .56?

[@jackcoveproductions]

make sure your meter is set on AC and NOT DC

[@apackwestbound5946]

John, thanks for the video education!

[@andywalker6168]

I have a 2002 225 EFI saltwater edition mercury with zero spark on all cylinders. Disconnected the kill switch and still no spark

[@clinthunt22]

My run at half speed got about 20 min all the way to my first fishing spot,fish for 30 min or so the restart it and take off and it runs great the rest of the day

[@ryanrosenbaum7893]

I’m only getting 3-4 volts at idle. Does this mean stator is bad?

[@Boaters_hub]

Sounds like it. Your getting 3/4 across the board on all plug contacts?

[@saintsfan7991]

Thanks for these videos, they are so helpful!

[@nordicdust]

Great videos as allways, thanks a million

[@BoatParts]

Glad you like them!

[@antonioprado8068]

@@BoatParts What if the charge coils part of the stater

[@antonioprado8068]

@@BoatParts never seen a video on testing charge coil yanaha that part of a stator

[@allanthomson4639]

thank you - great help

[@marioc4707]

Grate video

[@kenfoster185]

Mercury 60 hp stator test