Ford Escape 2nd Gen 2008 to 2012 Common problems, issues, defects, recalls and complaints

Ford Escape 2nd Gen 2008 to 2012 Common problems, issues, defects, recalls and complaints.
About Us : www.howstuffinmycarworks.com
www.jlsporttrucks.com
Cool Merchandise : www.redbubble.com/people/jlst...
howstuffinmycarworks-2.creato...
www.zazzle.com/store/jlstfast
Our Ebay listings : www.ebay.com/usr/jlst_fast
Our Etsy Store : jlstfast.etsy.com
#FordEscape #EscapeFord #Ford #Escape #Howstuffinmycarworks

[@fixfalcon2628]

I can't believe he didn't mention the top of the rear fenders rusting. Next time you see a 2008-2012 Escape, look at the rear fenders. EVERY single one of them has rust.

[@HansRiveraCreations]

ive only seen one without the rust.

[@CybrOpp]

What do I do if it's rusted? Or better yet, how to avoid it if it hasn't rusted yet?

[@adribouss]

No rust on my 2012.

[@boomerguy9935]

No rust anywhere on my 2008 Escape 3.0 VW with 148K miles. No leaks, no drips, no oil consumption. Just the fuel gauge acting erratically and the fan resistor not working on speeds 1 and 2. Both are fixed. Lots of scuffs and dings and worn out driver's seat which give it character.

[@hollisconant2566]

not ours sry to bust youe bubble

[@rogerwilcojr]

Honorable Mention: Rusted Read Fenders (almost every Escape in the parking lot).

[@lafamille7936]

No rust on mine so far (not living in the rust belt.

[@jeremiesims7783]

My 2009 Escape 2.5 Limited has had many of these issues but one I did not expect was a rear main seal bolt coming out and destroying the motor( due to it being compression fit) and trans (bolt punched a hole in the trans). After $2500 and many hours of work I got it back on the road with a used motor and Trans. All in all its pretty reliable and good on gas.

[@user-om6cf9wc9t]

I drive 2009 Ford Escape Hybrid Limited, 2.5L 4 cylinder, probably the most reliable Ford vehicle built. I did not have any of the described common issues. I have 107K mileage on odometer and needed to replace the following parts some known as really a typical for the 2009-2012 last generation of this model Escape - ignition coils, tire pressure sensor, A/C compressor, and HVAC driver-side mode door actuator (not blow motor resistor which is a common culprit for this model Escape).

[@lucygray6162]

I love my 2012 Escape. Handles like a champ on rural roads and no mechanical issues EXCEPT; The AC quit, (had to put it on 4 to get it to blow, then it wouldn't blow cold, the compressor burned up on the interstate) I have spent $1500 with three mechanics who got it blowing cold for about an hour before it steams up and fills with heat. And let me tell you, the heater could roast a chicken. I live in Florida, so this is a major issue for a vehicle, enough to force me to get something else. I've noticed in CarFax reports that both older Escapes and Edges frequently have way too many "AC Service" visits mentioned. I've also heard about an opposite problem with the heater, mostly with northern Escapes. They can't get the heater to come on but the AC is freezing them. I believe its something to do with the door actuator or possibly the blower motor mentioned here. Breaks my heart, love this vehicle, but I guess I need to take it to Alaska or Canada and sell it :-) I can guarantee it will keep you warm in a blizzard. :-)

[@cioclarityinsideout1997]

Yea, I have problems with my Ford with the AC. New Compressor and Hose $2672 later. And the AC still doesn't work. Great Vehicle on Rural roads but when ur living in the Pilbara you need AC.. Hopefully ford Dealer ship themselves can reset the AC issue..

[@justlg3359]

Was there any rust in the vehicle? Thinking of gettin a 2012 model lxt

[@jackdough8164]

I’ve had like 8 of the 10 lol but I still love these years of the escape. Word of advice to anyone though, get an 09-12 model since they’re much better than the 2008

[@notbxlloon208]

What makes it better?

[@Spoods872]

Hopefully going to get a 2012 tomorrow

[@TheyNerfedYou]

i have 2008 why is it better i’m curious

[@skurblord3401]

@@TheyNerfedYou In 2009 they redesigned the 3.0L v6 and got it pushing much more horsepower. Other than that its not really any better or worse. In 2010 they swapped out the traditional 4WD transfer case with a fluid coupler AWD one. You have to regularly change the gear oil in there otherwise it will fail. They also went from their 4 speed to a 6 speed automatic. You need to get a PCM update on 2010-11 to get the transmission to shift right though. Generally if you can get a 11-12 its the preferred models.

[@rs11200]

09-12 also got some feature upgrades like having the bluetooth sync system, and other features like ambient interior lighting, garage door opener and a backup camera. as well as was already mentioned a newer version of the 3.0 V6 and a 6 speed transmission vs the 4 speed in the 2008.

[@eamo106]

2011 running today in Texas, just changing the water pump at 67000 miles. NO other issues.

[@dewholdingsllc1050]

Thank for the content.

[@seanwalsh7264]

Forgot to mention the button for the rear hatch stops working or the many issues with the sync system for the radio

[@destroytacocat9070]

This was very helpful

[@Mike_The_Hog_A_Nator]

You are Spot On with the issues.. I got my Wife a beautiful super low miles 2009 "Non Hybrid" XLT 2.3ltr Escape for $2k from a Grandma/Grandpa Owner. 64k miles & looks show room condition. They only towed it behind their motorhome & seldom drove it but the 'Only' problem it had was the damn Steering Column! The dealership wanted almost $3k to repair! I just ordered a whole new OEM Steering Column off eBay for a $1000 and installed it myself in 2hrs.. No need for calibration, etc.. Like brand-new now. I got Carshield because of the known Bad Transmissions in the 2nd Gen & the Key Module. That key module is starting to act up now but it's still ok for the moment. The Dealership Maintenance Manager did tell me to stay away from the Hybrid Models because the batteries are out of warranty & only good for 6yrs & when that battery goes out? The Car becomes completely inoperable! Just junk. So stay away from those.. 🤟

[@27Zangle]

I am looking at an 08 with 12k miles, XLT, V6, and fully loaded with leather, moonroof, heated seats, etc. It has new tires and brakes too. I really want a Honda Element but I keep missing them as they are popular in Alaska and sell quickly! I am finding that most people say to stay away from the 08, however, this one looks practically brand new and is very tempting. It is hard to find a vehicle in my town for a good price without having to fly into Anchorage or make the 6-hour drive.

[@JD-ml7cg]

You have a link for the part?

[@jds1vette]

My 2010 Hybrid with over 200,000 runs great. Car Shield...lol

[@mr.2cents.846]

Thanks for letting me a know.

[@reysanchez4256]

Thank you

[@danieltaylor9761]

11 TransferCase (PTU) destroys due to proximity of exhaust manifold & lack of fluid change. 12 Condenser cracks and leaks transmission fluid. 13. Transmission leak @ LF Axle Shaft Seal due to support bushing wear/poor finish on axle shaft.

[@skurblord3401]

The PTU issue is only on the 2010+ models. The older manual 4WD transfer case was able to survive there safely due to it not being a fluid coupler. Still its always a good idea to change the fluid occasionally.

[@ruslannunez4449]

The suspension needs a beefier build . The next time my front end starts with that aforementioned clanking due to excessive and premature sway bar link wear. I will do my research and seek for that solution.

[@oitsbarb55]

ok! Safe! lol 2012 and I only have blower motor issues!

[@moneymanfernando1594]

So, do you recommend these vehicles??

[@carlosa2540]

I own a 2008 Ford Escape 2.3L and the following problems have arises at over 165,000 miles and here are how I fixed them; PROBLEM #2: I would loose power steering on and off at random times until one day while doing a sharp turn I lost power steering and almost hit the car next to me. #2 SOLUTION: The power steering on my escape is electrical and not hydraulic, there is a connection under the left side of the steering column that would loose contact since the wires were vent so hard the it was creating resistance to stay connected and with some random movements of the car the cables would loose contact. PROBLEM #5: The paint on my escape did come off in certain areas and would get rusty within one year as I live in Northern USA. Those vehicles tend to rust horribly bad if salt is used to melt ice in roads. Problem #7: Transmission was replace by previous owner at about 150,000 miles. I am currently at almost 200,000 with used replacement and no issues. PROBLEM #8: Turning key would sometimes start car and sometime it would not. Gave me a false idea that it was the starter but it wasn't it after replacing it and still having the same problem. Replace the ignition module as show in the video and it fixed it. Problem #10: Sway bar links would make clunking noise when going over bumps but it seems like they were the originals. Replaced at 190,000 miles but suspension are normal for every car depending on how bad are the roads(pot holes, etc.) Other problems I've had are; rusted hole in gas tank(looked man made), thermostat(car would not reach normal operating temperature) and most recently car shakes at park and drive so most likely its my motor mounts. Hope that helps!

[@FreeBrainChannel]

I thought about revising the contacts, but went to the mechanic with a used power steering motor fro mEbay and a new ujoint for some steering play. Mechanic told me to replace Upper steering shaft, but couldnt find the part locally... I am expecting it now, but the replaced PWS motor started with problems already. It sounds like a SPRING noise when turning the steering wheel. And already once had problems activating in start... Is the bought motor bad? or what could it be? Don;t want to waste more money.

[@thefunnyman713]

My 2008 hybrid escape wont go into reverse or drive, but before that it wouldn’t go into park

[@mafia461]

2009 FordEscape @1:26 electronic throttle body unit malfunction.

[@brianbaker359]

Just had to scrap my 2009 Ford Escape XLT v6 220,000 kms due to badly rusted and unsafe right front subframe which is a very common problem in area where salt is used on winter roads. Just replaced blower resistor for 3rd time. Rear windshield wiper motor replaced due to parasitic draw. AC too expensive to repair. Of course rear wheel well arches badly rusted like 90% of other Escapes.

[@mkeptrangli]

Had to replace the blower motor resistor in my 2012 escape at 118,000 miles

[@bedrock9709]

I have a 2008, mine went at 116k.

[@rogerwilcojr]

I've replaced it 3 times on my 2009 w/ only 90k miles and it's bad again. I give up.

[@fdimichele]

They can also vibrate like crazy at stop light apparently not from engine mounts because I replaced them and it made no difference. The 2.3 L engines last a long time but are underpowered for an SUV frame.

[@ElusiveTechBro]

Did you buy the engine mounts directly from Ford? It’s basically the only part that I think possibly matters to buy from them instead of aftermarket.

[@jdel2315]

What about the Bluetooth connection issues? Apparently that's in all models lol

[@DanielGomez-cf6vk]

Electronic throttle body is only issue I had on my 2010 escape

[@abdoforjani]

May i know for how long u have had ur 2010 escape and current distance?

[@jds1vette]

I had to replace mine too. I think I paid $50 on Amazon.

[@Tmhen]

2011 3.0 L V6 XLT rear wiper motor fail---- if you hear faint clicks even when key is off after driving, disconnect power to the rear wiper as it will drain your battery overnight to nothing. If wiper is not parked, it will cycle on & off all night long.

[@Jesus_is_the_only_way414]

I got a 2008 it’s low key trash

[@__7878]

F R A M E R U S T

[@bobetization]

i have a problem with power steering i want to sell this crappy car made in US of A & buy a toyota made in Japan

[@packleader1215]

Every vehicle is trash

[@relevation0]

My 2008 is a piece of shit deathtrap

[@TheyNerfedYou]

elaborate bro i have the same car

[@williams0025]

I have one too..some issues, but overall has been a great car

[@bedrock9709]

I have the same one, yes it is . One thing right after the other. I had the tranny rebuilt three years ago now it's leaking, steering column housing and blower motor resistor replaced. Now either the steering column shaft or drive shaft need to be replaced as well as the rack and pinion. The sub frame is also rusted out.

[@nathanking9083]

@@bedrock9709 I'm hear cuz 3hrs ago I lost the transmission on the highway in my 2008...I dunno if I'm going fix it or scrap it

[@bartholomew1096]

2011 is such a dog shit year for this car