This was the second time we got a HPE Gen10 server with a defective disk backplane for repair. In both cases, a capacitor on the 12V supply rail was shorted and the internal e-fuses tripped. But this time I cought it on camera :-)
Пікірлер: 18
@Matt_The_Hugenot2 ай бұрын
I wish my hands were that steady. Great work.
@horst.zimmermann2 ай бұрын
Nice job finding that fault
@PlaywithJunk2 ай бұрын
It's the only way that works.... Thermal cameras are cool!
@Gooberslot2 ай бұрын
MLCC caps are a menace.
@RoyHess6662 ай бұрын
New channel name: Repair This Junk 😀
@DeKempster2 ай бұрын
Lol, we are still running gen8. Rock solid but old.
@PlaywithJunk2 ай бұрын
The best HP servers were G7. G8 fail very often because the flash chip for Intelligent Provisioning fails. For unknown reasons, HP decided to solder that chip to the mainboard instead of using a removable SD card...
@SiaVids2 ай бұрын
@@PlaywithJunk And to make it a bit more difficult they were BGA NAND memory too, I've replaced a few and had no more problems. Apparently things got better with later firmware.
@PlaywithJunk2 ай бұрын
@@SiaVids I can't replace BGA chips myself. But I found a company that can do that for a reasonable price...
@PlaywithJunk2 ай бұрын
Regarding firmware... the Gen10 servers have a lot of firmware related problems. It started with the new Intelligent Provisioning that had bugs like a rotten fruit. I had a couple of G10 servers that had to be replaced because they refused to start after a firmware update. Fortunately most of them recovered in the workshop after resetting everything to defaults.
@benbaselet20262 ай бұрын
I hope you also reattached that smaller cap you accidentally pushed aside when resoldering the new part in .-)
@PlaywithJunk2 ай бұрын
Sure... it just was not possible to film that... my hand was in the way. :-)
@CATA200342 ай бұрын
Hope the replacement is at least 25V rated, also 25uf? I know the usual ratings are 10uf, 22uf. Soft term or open mode would be perfect.
@PlaywithJunk2 ай бұрын
These are all "recycled" capacitors and since they are from 23 to 26uF when measured, I wrote 25 on the container. I this application a few more or less uF's don't matter. And because the "new" cap is of the same size, I assume the voltage is correct.
@dorfschmidt48332 ай бұрын
Mini Döschen kommt von Licefa.
@PlaywithJunk2 ай бұрын
Weiss nicht wie der Hersteller heisst. Hab's bei einem Chemie-Kunststoff-Versand :-)
@dorfschmidt48332 ай бұрын
@@PlaywithJunk Kenne die Miniboxen aus dem "Licefa V11 SMD-Lagerkasten"😁
@PlaywithJunk2 ай бұрын
Dann haben die die auch aus dem Chemiezubehör-Handel 🙂