2006 Hummer H3 front end repair. Lower ball joint, tie-rod end and sway link replacement.
Пікірлер: 24
@peteriot159 жыл бұрын
Just so you know it makes it a lot easier to leave the tie rod connected to the knuckle when you're trying to break the nuts on the ball joints. Leave it for last. Good thinking on using the wrench as a spacer with the ball joint pickle fork :)
@2012Runnerboy4 жыл бұрын
You guys did a great how to video Thank you
@israelcastillo11435 жыл бұрын
Excelente video, muy interesante!!!!!
@israelcastillo11435 жыл бұрын
Saludos desde Panamá
@wanabesurfer10 жыл бұрын
Thanks Zach! Hope it helps!
@imtiyazkhan29215 жыл бұрын
Pyr
@ZachMontizor10 жыл бұрын
Great step by step video Thanks!!!!
@richardmccarrell2002 жыл бұрын
did the oem ball joint have a snap ring
@Chance217 жыл бұрын
That was a mevotech ball joint right? How long did it last for you? I just got one for my hummer and plan on installing today
@wanabesurfer5 жыл бұрын
Chance Selvidge has the truck for 4 more years and still looked great.
@xacahaygun85908 жыл бұрын
super
@2wheelTyler5 жыл бұрын
How did you remove the old one? Does that cap act like a c clip? Or does it just all press right out?
@MD-jp5oc4 жыл бұрын
I think they just didn't show them putting on the new c-clip that came with the new ball joint.
@johnnywashington58892 жыл бұрын
You never showed how you pressed out the old ball joint.....?????
@jcreeker5581 Жыл бұрын
At 7:05 they talk about how they used the ball joint tool to press out the old ball joint. It would have been great if they would have shown how that was done though.
@libralongstroke5 жыл бұрын
HOW DID YOU GET THE BALLJOINT OUT ?🤷🏾♂️
@wanabesurfer5 жыл бұрын
LIBRA LONGSTROKE I used a ball joint separator and a open end wrench. Look at 2:58 in the video
@edsgarage0013 жыл бұрын
Pretty sure he meant, how did you get it out of the lower control arm... Your video goes from it in there, to it out in a split second at the 6 and a half minute mark
@northernidahooutdoors3748 Жыл бұрын
Good video except you skipped over the lower ball joint removal process…
@wanabesurfer Жыл бұрын
I just rewatched that video 10yrs later and realized I left that out. Whoops. Honestly I can’t remember but I likely pressed it out with rental tool or put the nut on it and hammered it out with the sledgehammer. I think it was the latter since I was replacing the ball joint.
@northernidahooutdoors3748 Жыл бұрын
@@wanabesurfer same way I usually do them but was hoping you had an easier way lol.
@vloggershubby8 жыл бұрын
here uae macenc I now hummer corvte Ferrari lombrghni rolce rice
@kamilk69566 жыл бұрын
pretty shitty camera work though
@wanabesurfer5 жыл бұрын
kings hound feel free to send a camera crew over next time.