husqvarna k760 concrete saw fuel line repair

[@toddbishop9611]

Very simple to follow instructions and help me replace a cracked primer wall thank you

[@smallengineguys]

Glad i could help

[@dennybug2]

I have a Husqvarna concrete saw with only one hole in fuel tank for a fuel line obviously the suction. But I’m confused on the discharge side of the bulb as to where it goes. Only other port on carb. Is used as vacuum jumper from carb. To rubber extension piece that mounts on the block. Any ideas? Thx

[@smallengineguys]

There is another hole. Your just missing it.

[@dennybug2]

@@smallengineguys you would think but trust me there’s only 2 one for suction other is vent. I actually pressurized the tank to be certain. Actually I borrowed a friends stihl demo saw and it’s has the fuel line coming straight from tank to primer bulb and discharge going to carb. It’s pushing gas into carb. And runs like a champ. Hadn’t tried on mine yet. But I know 100% that my line from tank was going to carb ( like most do). But can’t hurt to try. Thx for responding. Godspeed

[@FDDLERSGREEN]

My K760 is the same. On the pull string side, there's a line coming up out of tank and (going to same side)a nipple on the carburetor. On the right side, the primer bulb has one hose coming out of one hole in the fuel tank (for fuel discharge when priming)and that's it. There's not a second hole or a second line or even a second nipple on that side of the carburetor for a fuel line to connect to. This is the way we bought it a year ago. There's literally only 1 nipple on the entire carburetor

[@stevenmunslow125]

Nice work

[@smallengineguys]

Thank you!

[@carlosvalenzuela2763]

Regular gas

[@smallengineguys]

Non ethanol gas mixed with oil is best.

[@carlosvalenzuela2763]

Thank you

[@Nicedicekid]

Hope your a better repairman then you are a cameraman. Try sticking the phone to your forehead instead of your chin lol

[@smallengineguys]

@@Nicedicekid all the other comments are of gratitude. Then there is you. Good luck in life.