HVACR: How To Remove/Replace A Fan Blade/Blower Wheel From A Motor (How To Use A HVAC Blade Puller)

HVACR: How To Remove/Replace A Fan Blade/Blower Wheel From A Motor (How To Use A HVAC Blade Puller) Sensible Products UP1 Ultimate Fan Blade Hub and Blower Wheel Puller Remover Tool /HVAC Fan blade Removal/HVAC Fan blade Replacement
Sensible Products Ultimate fan blade/blower wheel tool
amzn.to/34zAwVq
Ultimate Steel Hub Puller - Removes Fan Blades And Blower Wheels - Fits Up
To 1-7/8" OD Hub
Saves time and money
Wont damage blades or wheels
Accommodates 5/8" belt drive and 1/2"
Unique set screw can be used with both a wrench or hex key
Slight holes for aligning puller on motor shaft

[@robertmunguia250]

Wow! Just did one yesterday but I didn’t use the Allen claws just used the screws to tighten down but now I know claw way. Thanks!

[@gilbertopatino2616]

Thank you so much great video👍👏

[@bennybenitez2461]

Great video most helpful a hardy all American hand salute from American Legion Post 346 of Miami Florida 🫡🇺🇸

[@roberts1159]

Great presentation as usual. Thanks for sharing your knowledge.

[@bert1913]

I spray Kroil down the shaft, then remove the set screw and spray a little in set screw hole

[@izzybell11]

Interesting subject. Well presented and explained. Great 👍 job JMT

[@kennethlobo4420]

Great video. Thanks for the explanation very clear.

[@thesilentonevictor]

Great video

[@christianurbano1483]

Nice wrenchs have the same from harbor freight nice vid, thanks

[@I_name_All_my_guns]

Liked and subscribed

[@JParOO7]

Buena herramienta

[@joedance14]

Is this type of puller a one-size-fits-all? Or are there different sizes? If the latter, how do you determine the size needed?

[@I_name_All_my_guns]

Thanks for the informative video

[@jericomontano2016]

What if you don't have that claw tool? How do you take the blade?

[@woodheat411]

Did you clean the axle in front of the blade and add oil first? Can you tell me how to get a cast aluminum blade removed from a steel shaft?

[@SoutheastHVAC]

Wow. I’ve been doing this for 4 years. And never knew those Allen wrench looking things were to attach to the puller. I never read the instructions! I feel like an idiot😂

[@paulfriedlander1831]

What size socket is that?

[@kmart6026]

How do I get a van??

[@shine-cg9uf]

💪💪🇺🇸👍👍