Infinity Flow makes 3D printing easier than ever

[@TheNewBloodDan]

This reduce waste too! Sometimes near the end of a spool I'm afraid of running out so I pause and switch out filament with some left which ends up just sitting around somewhere.

[@MrKancerXb1]

what about direct drive?

[@3D_Printing]

How about Filament breaking, Filament tangles, Filament coming off the spool. what happens if two spools are not enough i.e no filament left

[@MatijaFistric]

If two spools are not enough you can either daisy chain them infinitely, swap out the empty spool mid print while the other spool is printing or just get 2 bigger spools i.e. 5kg spool on each side, so you have 10kg of material without the need to swap, which should be plenty😅