Install Rough County MOLLE panel

This install is the passenger side MOLLE panel on a 2020 Jeep Gladiator. The driver side is identical. My Gladiator has no bed liner and I used it with the bed system. Over all it took about 20 minutes to install.

[@HammerJT]

Great video! Helped me out on my Molle panel research for my JT; lots of choices out there. These panels seem to require the most effort and modification, but are the least expensive from what I have seen so far. I like the self tapping screws idea too; not sure if wanna drill into the Jeep, but at the end of the day its just a Jeep so no big deal really I guess...I have done much worse to my previous Jeeps.

[@billyjack505]

I’m glad it helped! And I agree, with the panels provide versus the little pinhole’s, I’ll take the pin holes. I’ve already had them on for a few months and they’re still solid and I use them all the time. Have a good day!

[@thetankslapper]

Drilling into my bed is a deal breaker.

[@jonluchessi1643]

Do those molly panels rattle?? 👍

[@billyjack505]

Not at all! They’re solid.

[@AceRiderLA]

Hi. Do you have a link to this?

[@billyjack505]

www.roughcountry.com/jeep-modular-bed-mounting-system-10631c.html This should work 👍

[@cjerico]

Wish I knew I had to drill before I bought it ☹️

[@billyjack505]

I felt the same way. But honestly these have came in way more useful than I imagined, and I would drill into the bed for a toolbox so this is the same to me.

[@starrskreamgaming]

after you drill the holes, before putting in a rivnut just use some touch up paint on the hole to reseal the paint. honestly though, those rivnuts are on so tight i doubt you would have to worry about rust.