Installing 2-Inch Flush Mount Lights in a Bumper

[@Turbo4Joe363]

If you don't put primer and paint on the bumper's raw steel cutouts, they're going to rust badly in no time.

[@mustangmike387]

I installed these on my 2021 Ford ranger this past weekend and I would highly recommend them the quality of the light is very good

[@eddiesmith9836]

Thanks for not finishing up complete installation you kind of trailed off after running the line to the battery, that's the most important part, power! switch! jeez!

[@masonhock6442]

I'm considering purchasing these, but my bumper area is relatively small. I have about 3.5 inches of flat bumper. You guys say its 2 inches, but does that include the housing? If not, could you please tell me what the dimensions are with the housing included? Thanks!

[@mannyloko4504]

How do you run the wires in the cab from the back + is the wiring harness long enough to reach the battery at the front

[@TheBbg3000]

It’s not long enough

[@living2learn138]

Is a relay needed for these lights?

[@gewglesux]

Relay should always be used if above a 2 amp draw. Most people on here dont use one...

[@beakfish7319]

depends on what your switch is rated for.

[@heberlara6079]

Nice looking lights, extremely annoying voice.

[@beakfish7319]

i dunno if theres much he can do to fix that...

[@heberlara6079]

@@beakfish7319 of course he can, he can stop trying to fake a deeper voice, clearly his tone is normal/average.