Installing 4-Way Jack Patch Modules

[@williammorillo657]

And how does it connect to the pedals???

[@MistaSCARY]

How do the LED lights fit around those modules?

[@goderaj]

Will 4 right angle jacks fit on the inside connected to the 4 jack mod? Specifically boss cables?

[@jameshieb5483]

Those blank panels with the screws won't budge after taking out the screws on mine. what am i doing wrong?

[@Heavyfher]

Hi guys!! I’m trying to ad a Powercon and a and a 4X Mod to my Templeboard, but for some reason after removing the screws when I try to remove the blanks from the pedalboard side panel, they don’t come off, is like they are glued or something. Any suggestions?

[@sergiojgonza8605]

im in the situation as well. please tell me you figured it out and how ?

[@Heavyfher]

@@sergiojgonza8605 In my case I had to take the screws of and then hit the plate with the back of the screw driver from the outside to inside. Looks like the paint from the sides of the templeboard is done after they put all the plates together and for that reason it gives hard time to take it of. Good luck, hope this helps you!!

[@christopherheadcase6886]

If I am running a SD power stage on my temple board. Can i run the output of the power stage Into the temple 4 way patch to put to the cabinet?

[@templeboards]

Yes, as long as you're not putting a really high wattage amplifier through the 2X and 4X MOD then it will handle a powered signal great. The 2X and 4X MOD's power handling capability is as follows: 600W into 16Ω 300W into 8Ω 150W into 4Ω Ensure you use proper speaker cables on either side of the MOD.

[@christopherheadcase6886]

@@templeboards since I'm looking at the v1 mod not the V2. Is that each input or total?for example if I was running a stereo pedal power amp

[@templeboards]

There is no V2 of the 4X MOD. There IS a V2 of the 4X MOD Pro. You definitely DO NOT want to put a powered amp signal through any of our powered MODs (incl. 4X Pro V1/V2, SUM MOD V2, 2X Pro). You can only safely do this with the passive 2X/4X.

[@christopherheadcase6886]

@@templeboards my apologies.. ok so with the 4x mod. Are those parameters per 1/4 jack or a total of all 4? Cuz I'm wanting to run a stereo pedalboard power amp to dual 2x12 (one on each side of the stage) they are 200w 8ohm cabinets and the pedalboard poweramp is max rated at 250w stereo into 8ohm

[@templeboards]

@christopherheadcase6886 Per jack. All jacks are isolated from one another.

[@Booze4Blues]

This module is an OK feature and not subject to the same stress as the under-engineered IEC module . . I don't anticipate any on the road problems for my son. Time will tell ! But I'll stick with my Neutrik fitted Pedaltrain !

[@shaft9000]

Trying to like this line but so much wasted space&opportunity on the buffr and summing modules, ...what's the damned point of needing two units to get four when a deeper single would have been much better. And to boot, a professional output module needs ground lift and phase. So at this point it's the friedman system, hire an EE to put together a cu$tom gigrig, or become an EE ....or you just 'risk it' with this kind of stuff wherever you go/ ....*sigh*

[@ThaynanBotelho]

Plastic jacks lol