Introduction to Using Signal Tap

[@TerryCarpenter-nu4cs]

So much better than those Intel videos that just drone on and on for hours before they tell how to use the DAMB tool. This was just what I was looking for. Thanks so much!

[@yhkao5268]

Thank you. The presenation is very clear and very helpful.

[@dougsmith5873]

Very well presented.

[@giancarlokuosmanen9723]

Thanks a lot!

[@guillaume8437]

Thank you for this video. 1) you set 64bits of RAM and we can see you have almost 64 samples on your waveform... if you double this RAM, you will have 128 samples, right? 2) if you add another 1-bit node, will it require you to double the RAM to keep the same number of samples? 3) the system requires us to recompile every single time I change something in the setup, number of nodes or even simple the trigger conditions, do you have some solution to avoid this?