This is great! I have a 90 degree corner clamp that I bought, but the ability to change out the angles is awesome! Thanks for sharing!!!
@jtronicsTV3 жыл бұрын
Thanks. 👍
@ariekatz452 Жыл бұрын
Thank you for sharing this jig. This is a beautiful design. Please note what Infill percentage do you recommend for each part.
@BlueMouse_pl Жыл бұрын
super project ! Thank you !
@snarkfinder26213 жыл бұрын
That is a really nice tool.
@jtronicsTV3 жыл бұрын
Thank you 👍
@ponsaravanan Жыл бұрын
Good one
@gbinford90093 жыл бұрын
Cool and useful project, thanks!
@jtronicsTV3 жыл бұрын
Thanks! Yes, its really usefull.
@LesTutosdUneMinute3 жыл бұрын
Very cool!
@jtronicsTV3 жыл бұрын
Thanks 😀
@ollybarry66203 жыл бұрын
This is awesome! When you put the stud bar into the grey slider is it just screwed into the plastic? If so then what stops it coming out when the clamp is loosened?
@HurtinVR3 жыл бұрын
hey i know this is a old reply but i made these and honestly that isnt an issue. if you think about the clamping pressure when you tighten it up its going to butt up against the thing its holding, but when you losenit you just slide the plastic back as it loosens up. i havent found a way to keep the screw in the base attached since it has to rotate
@jonathansfl12 жыл бұрын
1x hex bolt (5/16" x 4.5") 1x hex nut (5/16") 1x machine screw (8/32" x 0.5") 2x machine screw (8/32" x 3/4") Don't bother printing the knob. Use the hex-head on the bolt. Make matching parts with same colors. Use different colors for different Degrees.
@DavidBlevins3 жыл бұрын
Amazing design. What printer do you have that you could print all that in 6 hours? That would take more than double on my Ender 3.
@jtronicsTV3 жыл бұрын
I have two ultimaker 3d printer. One ultimaker original plus, which I upgraded to an ultimaker 2+ and an ultimaker 3 Really good 3d printer! My filament is from Formfutura or BASF
@HardCoil3 жыл бұрын
Thanks
@xXGreenGamerXx3 жыл бұрын
Great project my dude, where are you from?
@jtronicsTV3 жыл бұрын
Thanks and there are more projects ... 👍 I'm form Germany.
@senorduck3842 жыл бұрын
I just had this printed for me by a friend. And will say it doesn't work very well for frames. Haven't tried it on vertical pieces yet, but for flat 2.25 x .75in thick pieces I'm struggling to get proper pruessure without them getting pushed out.