Lippert Theater Recliners Pull Cord Replacement

[@ournewseason]

Tx! We have a 2024 32rls. Our pull is OK but I can imagine it happening in the future.

[@checkingitoutwithrich5711]

Try to pull straight up using the hand that on the same side as the pull. Pulling across your lap put a lot of stress on the cable. Should make it last longer. How are you liking the 32?

[@tonyt3590]

Hey Rich,,,, I just changed my cable out on ours also,,, ordered the cables from amazon,,, what I did was pull the recliner out, take the back off and was able to replace the cable. That screw in plate was a pain,,,,now the handle sits a little higher in the seat

[@checkingitoutwithrich5711]

I just secured the seats to the floor so I was trying to avoid removing them again. Everything was pretty except for the screws on that mounting plate. I think if I do it again I'll move it down where I can gat to the screws

[@ournewseason]

Loving it! We are on our 5 month AK trip from FL. I DIY'd / upgraded the MoRyde to their Altrek 4000 and added SumoSprings. I also DIY'd a 600ah Lithium battery system without adding Solar (next project) and Hi Perform Starlink. Only minor AK incident was screws came out of the closet barn doors hangers. Terrible design! I was able to put a bolt in the bottom hole. However, unrelated to AK trip our Auto Level needs repair. During this trip, Alliance sent me a new controller board but still prob. I need to open access panel to inspect rear end level sensor. Also, Black Tank doesn't empty correctly. it seems the valve doesn't open all the way. Even with clean water it doesn't flow like gray tanks. It only flows 50% of the hose volume. The pull handle is much harder to pull than the other gray tank pulls. I am not sure the issue. Also, I had to install the CAMCO extra tank valve handle due to black tank liquid (approx 2 cups) would leak out during a trip. Made for a "not fun" hose attachment task! Hahaha But all in all, we love our Ally...

[@checkingitoutwithrich5711]

@ournewseason how are you liking the Altrek 4000? Heard a lot of good reviews on it. Might be a good fall project this year. That camco valve has been my first purchase on my last campers. Stay safe and enjoy your journey

[@rvgossontheroadagain8052]

It’s always something!

[@checkingitoutwithrich5711]

At least it didn't cost me $75

[@OmahaWayne]

What a pain in the ass

[@checkingitoutwithrich5711]

Pain but worth it. Dealer would have it for two months, change the wrong one and charge you $450