Mazda 6 2.2 Skyactive Map Sensor test and change

[@R5GTT]

I’ve found copy eBay sensors to be a touch and go thing. Testing the sensor is very important 👍🏽

[@zakshafi7595]

Thank you for your tips and honest advice 🙂

[@ChrisEllison1980]

What obd tool are you using please? I am have issues with the mazda 2.2 also

[@zeljkoplavsic9322]

Thanks 👏👏👏👍👍👍

[@gknight8526]

Very well explained. Many thanks.

[@petreaciobanu7390]

Hello , have you ever met the P2262 fault code in Mazda 6 2.2d skyactive ? What can be ? The message is Turbocharger TC boost pressure not detected . Thank you .

[@Gacronos]

I have a value between 4 & 6/7 for both of them when Ignition On without acceleration, is it normal ?

[@carcity7153]

Hi. What is the scan tool you are using that shows the desired value? What scanners can do that? Thanks

[@thefix9823]

Hi I am using thinkdiag

[@cb-wo9tk]

Hello my map sensor when connection unplugged reads 320kpa, also if connected it reads 98kpa those readings all with ignition on engine off. I've changed 2 sensors thus far same thing got technicians to test the connector says its fine?? Idk what else to do. I'm getting low boost turbo charger A. This the only thing I see as a issue plz help me😢. 2014 Mazda atenza 2.2d

[@carboniloko]

I like your videos Sir,very clear and direct to point. Where are you based Sir? tks.

[@thefix9823]

Hi I am based in East London

[@pauloag1977]

Hi there just found your 2 vids on exhaust pressure sensor and this one. I'm wondering what software are you using on your mobile to check the fault codes etc please? Thanks

[@thefix9823]

Hi I am using thinkdiag

[@pauloag1977]

Thank you 🙏

[@paulsamways1716]

Hi thanks for this, I got a new OEM bosch sensor but the kpa still read 10kpa and only goes up to 18kpa when revving engine. I checked the wires with multi meter as you showed and the one of the wires (signal I think was only 3v) so I know it's a wiring issue. Unfortunately that goes beyond my knowledge messing around with PCM. Is it likely to be an issue with thr PCM or physical wiring issue (broken etc). Many thanks. Without this video I would have been buying new senors like you said

[@MartinML13]

How you fix your problem? Thanks for answer

[@jackdaniels3728]

Hello, did you fix this

[@MartinML13]

@@jackdaniels3728 if do you have friend with same car use him sensor and check scan(live date) how throttle body working ....i bought second hand £10 maf sensor and my car is ok

[@MichaelStieger-Bäck]

Welchen Nummer hat den neue Sensor von Bosch 261230318 oder 261230319

[@vezniuc.f.claudiu]

@paulsamways1716 Did you managed to get it fixed? I'm having the same issue and got the bosch sensor 261230318 and it's still 10kpa

[@remotaurog]

Verify that the MAP PID (pressure) and barometric pressure are practically equal,🤐

[@alland2888]

buy cheap buy twice always go genuine.