Memorial Flag Display Case

In this video we make a pair of memorial flag boxes. My grandfather and his brother were both war veterans and my father decided to display their flags. So I did two different builds. The first one was without any planning. The second one I planned out to make it a little easier.
ETSY store: www.etsy.com/i...
Website: www.woodpackdi...
Instagram: / woodpackdiy
Bob Barker's Instagram: / bobbarkers_. .
Affiliate links for tools, I make a small commission on qualifying purchases at no extra cost to you.
Tools:
DEWALT 10-Inch Table Saw (DWE7491RS): amzn.to/3z4vcDU
Freud Diablo 10" 50 tooth ATB blade: amzn.to/3pnPCDz
DEWALT 20V MAX XR Cordless Router (DCW600B): amzn.to/3fTc2te
Dewalt 20V Max Cordless Drill/combo: amzn.to/2Rqy50V
Dewalt Palm Sander, 1/4 sheet: amzn.to/3ikKa2U
24-piece router bit set for ¼ in shank: amzn.to/2RqJpdz
Tape Measure: amzn.to/2SdP0nJ
Mechanical Pencil: amzn.to/3uT8mfh
Wood Glue Dispenser: amzn.to/3ppyZYa
Safety Ear Muffs: amzn.to/3cnvqMG
#flagbox #shadowbox #memorialcase #woodworking #DIY #ETSY #woodworkingplans #memorialflagcase #flagcase

[@MrJerseyboy2377]

Nice build. I did not see a link pop up in the corner for sled build.

[@Lutzboater]

Made a memorial flag case for my Mom who was a WWII Vet. As you said they are not too difficult to make and turn out beautiful. Thanks to your family's Vets for their service to America.

[@woodpackdiy]

Thanks for you Mother's service as well! Also, did you ever get my message about the charcuterie board?

[@Joker_68]

Nice display case Anthony.

[@woodpackdiy]

Thanks!

[@310WoodWorks]

What width lumber did you use?

[@woodpackdiy]

about 1/2 in thick lumber. The case ended up about 4 3/8 wide.

[@thegrayjedi5202]

Hey nice cases you made! I’m wanting to make one for a friend who lost a veteran in their family and I don’t have their flag to measure by. Is there a standard dimension for these flags and cases that I could use?

[@woodpackdiy]

I am not sure if there is a standard size. This was the firt time I've made these as well. I just went off of the size of the flag we had. The final size of the case ended up being about 21 3/4 long for the bottom piece and 15 3/8 long for the sides.