Check out www.MercedesSource.com for another video. Also see this guy: • Crankshaft Position Se...
Пікірлер: 10
@rolof57953 ай бұрын
I couldnt do it by hand will try pliers tough spot and tight
@figgiefigueroa73724 ай бұрын
Good video 🎉🎉
@dbond69874 ай бұрын
Went to auto part store, they scanned it for me. It was the crank sensor, i completely the install , but car still cranking occasionally, any thoughts as to why? Thank you Some video says it needs to be programmed… but most say it doesn’t need to be programmed
@DavidMSyme4 ай бұрын
It 100% does not have to be programmed. I am certain. It is just a simple magnet. If the Sensor was bad, it would almost NEVER catch and fire up. If its cranking, it is probably something else in the ignition. Just my thoughts.
@dbond69874 ай бұрын
@@DavidMSyme thank you for a prompt reply. I just put the new one and it hasn’t cranked as of yet just turns over. I feel as though it will crank eventually though.The reason I put the new one on. Is because the old one, would only crank once every 12 hours or so. Tomorrow I’ll put the old one back on, and see if it cranks. Thank you
@jamesharwell11 ай бұрын
You are right that no one explains these details! They plyers and the grease - Couldn't have done it without your help! Thank you!
@jaygardner93939 ай бұрын
I have been thinking about doing mine. With your video, I think I will. Thank.
@craigfogg207110 ай бұрын
I’m about to get into that project, thank you for the tips!!!!!