MiterSet Segments lets you quickly and accurately set your miter gauge to the precise angle required for cutting a wide range of segmented frames. Learn more: www.rockler.com...
Пікірлер: 12
@oldsloane5 жыл бұрын
I am very disappointed in my miter set increment jig, I have checked all the alignments on my saw and tried the jig a few times with very poor results. I tried an eight segment and had to sand three of the pieces in order to get a tight fit, ditto with three rings today with 10 segments. I bought this jig after hearing all the great comments about accuracy and ease of use. I don't know what I could possibly be doing wrong as I have been very careful with setups. The last 10 segment ring I made I had to shim the 00 pin with a blade from an exacto knife and it turned out perfect. ??????
@1960fusion7 жыл бұрын
The good thing about it is that if you set the miter gauge at a perfect 90 degrees with this jig and make a cut on the saw and the cut is not square, it will indicate that the miter slot is not parallel to the blade and is need of adjustment.
@horseblinderson47474 жыл бұрын
You should have shown the 22.5° on the segments too. Just pulled it over and dropped the 8 pin in.
@mr.apparatus91088 жыл бұрын
Awesome
@norminatorrr3 жыл бұрын
It's discontinued.
@oldsloane5 жыл бұрын
I am still very disappointed with this jig, I have found that the only way I can get a perfect glue up is if I shim the 00 side 35 thou. Funny thing is I have searched for a contact for the company and cannot find one. I would like to give them the benefit of doubt but I am starting to think this thing is just a rip off gimmick!
@MarkTurnbull5 жыл бұрын
Took me 30 seconds on their website to find this.... "You may contact us at (571) 310-5088 or at CustomerService@MiterSet.com"
@gerrylundergaard604 жыл бұрын
What I find disappointing is the fact someone went to great lengths to manufacture a poorly designed billet machined block with loose parts. This is no substitute for a simple compass or sign bar. Pay attention or pay cash!
@valveman125 жыл бұрын
I just use a compass and can cut just as accurate as this jig.
@WV5917 жыл бұрын
Don't fall for this gimmick miter gauge has to be aligned to miter track.this is useless.
@jbn06135 жыл бұрын
Well, of your miter slot is not parallel to your blade, you need a new saw!