Mojo 3D Printed Ligature Assembly

[@marsax3]

I leave here my congratulations for all your videos. By sharing his vast knowledge, today I can adjust the mouthpieces of my clients here in São Paulo, Brazil much better.

[@antealunanera]

Bellissima!!!!!!!!!!!!!

[@DavideMarzola431]

Hi, great work!!! May I ask what is the diameter of the Kevlar wire you used? Thank you. Cordial greetings. Davide.

[@mojobari79]

Listed on Thingiverse: Hardware needed: (1) M3 x 30 screw (black Phillips pan) (2) M2.5 x 5 screws (black Phillips pan)… Can remove them after wedges are pressed in place. (1) M3x5x5 brass threaded insert for nut or M3 thumb nut of your choice (1) 2mm dia Kevlar cord. I use 9KM DWLIFE Black Braided Kevlar String 700#

[@DavideMarzola431]

@@mojobari79 OK !!!! Many, many thanks.

[@hvalenzuela8]

super !!!!