i drilled / tapped flat area on top of truck water pump for steam port ran to a brass nipple for my monte ls swap project, also the same for my k10 lq9 build.
@JoseSilva-nl1iv2 жыл бұрын
Working also on a G-body (grand prix) but interested on that thermostat housing. Is it from a Chevy small block?
@robertchalk81933 жыл бұрын
Whats the part number to those rubber bushings
@josecervantes97082 жыл бұрын
What type of ac compresor did you put? Brackets?
@GBodyJosh3 жыл бұрын
Hey man I got the same radiator for my 79 cutlass and am having troubles with clearance. Any tips?
@hogansmith75894 жыл бұрын
what is the make and model for the radiator and does it come with trans cooler. any modification needed for gbody
@GonzosGarage4 жыл бұрын
Its just a amazon special. And yes it has a built in trans cooler.
@GonzosGarage4 жыл бұрын
I put a link to the exact one in the description.
@hogansmith75894 жыл бұрын
If you could drop that link I would appreciate it, thanks
@GonzosGarage4 жыл бұрын
Done!
@ruccimack973 жыл бұрын
Great content 👍🏽 I'm doing a 5.3 ls swap in my gbody and did you have any issues with the usage of those fans?
@GonzosGarage3 жыл бұрын
Zero issues. I think I put a link in the description to the setup I used
@ruccimack973 жыл бұрын
@@GonzosGarage ok👍🏽 Another question, what degrees thermostat is great to use for this setup?
@GonzosGarage3 жыл бұрын
I ran a 180 and the car never gets over 185
@ruccimack973 жыл бұрын
@@GonzosGarage ok great👍🏽 Thanks alot for the info bro, I've read so many good and bad comments about this radiator, fans and strout so I'm trying to gather up all the right information to have mines so again... Thx!👍🏽👍🏽
@GonzosGarage3 жыл бұрын
@@ruccimack97 if the fans are wired properly with relays and the properly sized wire they work fine but are not high end fans. As far as the quality of the radiator and fan shroud, best bang for ur buck u can find.
@jhawkins4512 жыл бұрын
How is this radiator holding up?
@GonzosGarage2 жыл бұрын
Good. I've used it in multiple vehicles.
@jhawkins4512 жыл бұрын
@@GonzosGarage thanks I'm ordering now
@mikearnold41982 жыл бұрын
What is that 90° hose that you have on there ?
@GonzosGarage2 жыл бұрын
I bent a piece of metal rod in the shape i needed the hose to be and went to the parts store with it. Matched it up and it worked out for me.
@mikearnold41982 жыл бұрын
Thanks man your page is awesome been a big help on my cutlass build
@mikearnold41982 жыл бұрын
Hey boss did you have to modify the radiator I order the one with fans off of your link and it seems like it's too big
@GonzosGarage2 жыл бұрын
@@mikearnold4198 I did not. I checked the link and it says it's for the MonteCarlo like I have. I ordered it from Amazon. I'll check the measurements on mine tomorrow