MR2 Spyder Rear Knuckle Rebuild Part 2 - Wheel Bearings Hubs ARP Extended Studs

[@jacksonli6135]

this two parts of the remove and install video is awesome! clear image and explanation! helped a lot on my fix!!!!!

[@RelentlessRacingAJ]

@@jacksonli6135 welcome. Pls subscribe. Thx AJ

[@thebritishhippie9735]

Great video, thank you so much! Took me about 20 minutes to remove my bearing after following your steps with an Autozone rental tool very similar. At first we tried removing it wrong and didn't see the lip until I removed the whole knuckle.

[@RelentlessRacingAJ]

@@thebritishhippie9735 I appreciate you watching and commenting. Pls subscribe. Thx AJ

[@scotched9682]

There are a lot of hub and wheel bearing videos on youtube, but once again - your videos are proof that it's not what you say, but how you say it. It just so happens that my summer TODO list has been arm bushings and then wheel bearings. I recently battled my front lower control arms bushings without the use of a press, your video has me thinking that the 20T HF Press might be the next move. Would you recommend it? Are there any other alternatives? My complaint is that space is limited for me, but the cost to bring my rear knuckles to a shop would be close to the cost of a press I imagine.

[@RelentlessRacingAJ]

@@scotched9682 thank you for the kind words. I haven’t had any issues w my press, but note I modified it w a HF air over hydraulic bottle jack. If I had to do it all over again, I probably would have bought the OEMTOOLS 25087 bc it is air over hydraulic, has a pressure gauge, and a moveable ram. However, it is more expensive. My friend bought it and he let me try it out. It worked well. Stay tuned for Part 3. Thx again, AJ

[@maxfish5808]

Do you apply any grease to the wheel bearings exterior before pressing them in?

[@RelentlessRacingAJ]

Yes, on the OD prior to pressing. This helps w the pressing process. And then again on the inner and outer surfaces to help with corrosion prevention. Thx for watching and commenting. Pls subscribe. -AJ

[@RelentlessRacingAJ]

Anyone recognize the mistake I made? It is fucking hilarious.

[@beyxiong]

Heat shield?

[@RelentlessRacingAJ]

@@beyxiong correct! I eventually got some new dust shields and installed em. OCD is real. Thx for commenting and watching. You are officially one of four ppl who watch my channel. Pls subscribe. ✌️AJ

[@beyxiong]

​@RelentlessRacingAJ, thank you. Your videos are very helpful. Waiting on the front t3 front lca install video.

[@RelentlessRacingAJ]

@@beyxiong thx again. I completed the front T3 install. Still need to edit the vid tho. Stay tuned. Hit that notification button & subscribe. -AJ