My 240sx KA24DET engine bay

[@MotorMonks919]

Thanks for the informative video man. This is almost exactly what I want to run and this helped a lot. Thanks man!

[@MotorMonks919]

A year later and I finally have my build together. KA24DET with a 2871r. I referenced your video a lot when looking for hose routing and all that. Thanks again for making this.

[@rustydomino694]

@@MotorMonks919 finishing up mine too almost after a year :)

[@rustydomino694]

@@MotorMonks919 keep in touch let me know how it runs!

[@MotorMonks919]

@@rustydomino694 it’s running pretty great! Slight misfire at idle, but I’m not too worried about it right now. It’s heat soaking a little bit after LONG drives, but I plan on a bigger intercooler and some heat management wrap/tape/ etc.

[@rustydomino694]

@@MotorMonks919 Nice! Did you rebuild the engine too? I'm having a lot of trouble trying to install my transmission lol, no luck in getting the splines to align even when I know all the parts fit

[@Ninjaboy459]

Incredibly informative thank you

[@ACommenterOnYouTube]

I went blow thru maf because i could never get it to idle right with open bov or with recirculated bov. Once i went blow thru, it now drives like its non turbo. My valve cover vent and pcv both go to a catch can and then dumped to the rear by the muffler. I dont want that nasty blow by oil/fuel vapor going back into my motor.

[@abewright4584]

Did you have to trim your fan shroud to fit a koyo?

[@chrisibarra5586]

Bro! 👏🏼

[@MarreroBuilt]

#Duvallllll! just subscribed im local in jax also.

[@christosfloros2359]

What size injectors are you running?

[@RonniegalloGT]

720s but 550s would of been fine.

[@lgsus4209]

thanks for the vid i want more lol

[@christosfloros2359]

What rpm does it hit full boost at? I'm planning running the same turbo

[@RonniegalloGT]

3500

[@christosfloros2359]

@@RonniegalloGT thanks!

[@Kaizen240]

What intercooler piping are you running?

[@srmx518]

Second this!

[@RonniegalloGT]

I think it’s crx racing. bought it second hand.

[@Therealzenkouki]

What kind of BMC (Or brake booster) do you have? You have a lot of clearance between your turbo and the brake lines.

[@RonniegalloGT]

z32. clearance is from the manifold.

[@Therealzenkouki]

@@RonniegalloGT Awesome thanks homie!

[@guillermobocanegra350]

Did you tune it yourself ?

[@RonniegalloGT]

No. RS Enthralpy

[@guillermobocanegra350]

@@RonniegalloGT I bought an ecu with es enthalpy tune only probably I don’t know what base tune it has tho 😅

[@RonniegalloGT]

@@guillermobocanegra350 you need to mail it to him and tell him your setup.

[@Ebk1988]

Do you still run this set up or swapped it

[@RonniegalloGT]

Still run it

[@Ebk1988]

@@RonniegalloGT total cost of build ?

[@RonniegalloGT]

@@Ebk1988 hard to say. I built it myself and swapped parts. About 1g in machine work. 1g for internal longblock parts. 3g in turbo parts. 5g makes sense