TODAY IM CUSTOM NARROWING MY BEAM ON MY VOLKSWAGEN SO MY WHEELS WILL TUCK NICE IN MY FENDERS
Пікірлер: 15
@jacquelinechellis4036 Жыл бұрын
You could section the peices you cut out and roset weld them inside tubes leave a gap for the full bead weld.
@aliveandwell20783 жыл бұрын
Ah ha, I asked the question to early. Nice job!
@kpvideos41623 жыл бұрын
I’m glad you watch till the end . Thank you .
@piretdnb27644 жыл бұрын
Dope!!
@kpvideos41624 жыл бұрын
Piret DNB thank you . You are the winner of the giveaway as you are the only one that did everything, I’m going to try to make a live today to tell everyone you won.
@sammysmith83943 жыл бұрын
Whoa nice welds😂😂😂
@kpvideos41623 жыл бұрын
Just tacks for now that's some thick metal.. but came out good after grinding and paint . Thanks for the support 🙏
@aliveandwell20783 жыл бұрын
How do the beam mounts fit to the pan since 4” was removed from the center and not the ends?
@MONTESGERAR Жыл бұрын
Cutting the pan 🦖
@blakeerdmann4 жыл бұрын
Do you have to cut the body to fit the beam with the shock Towers?
@kpvideos41623 жыл бұрын
YES YOU COULD BUT I WENT WITH OUT SHOCK TOWERS
@arizonarattlesnake41034 жыл бұрын
Whats up on the bug susp?
@kpvideos41623 жыл бұрын
It’s done have to do a update
@nniqulaschapman90462 жыл бұрын
Dont! do this. Cut it out of each side not in the middle
@MONTESGERAR Жыл бұрын
Cutting either side is fine . I’ve done like 30 I beams cutting from the middle . Narrowed and adjustable