Настройка передней части QubicaAMF

[@mrgments]

Nice presentation, but there is an easier (organic) way with much much less steps. 2:35- don`t use a hammer...try with wrench from 4 to 9 minutes is total mess the order of the action is wrong. First check and set if it`s necessary possition of the table (7:30). Then set the table to be parallel with pindeck, and that can be much much much easier than you show us from 4:00 to 6:40.

[@mrgments]

привет друг, do steps from 4:00 to 4:50, go inside the beckend of machine. On the carpet. From the other side of table, behind the 7 to 10 pin line, put the gauge tool between screw and pin deck, and try to see it. Check all 3 points. Do it on worst working machine. And I will explain to you what is wrong with manuals. contant me on [e-mail]

[@СартакСС-и3ш]

Здравствуйте! А по какой причине ,ножницы не зажимают до конца ,-все ? Ножницы все зажаты до предела , но и этого не хватает ,чтобы захватить кегли?

[@СартакСС-и3ш]

ВИА боулинг

[@rickymole711]

Good information 👍

[@СартакСС-и3ш]

По ножницам смотреть с 16-ой минуты.

[@edhouse1951]

Be nice if video was in English

[@jeevan2822]

Double pin drop