NC750X 2016 Dyno run

[@lucianoborzi]

the result??

[@EliasLadas]

Can you post the detailed results and if you have done any mods or the stock ? Thank you!

[@antoniovidigal]

Top speed on 6th gear until cutting on 7000rpm?

[@danvol8719]

io ho l integra 750 2016 e danno 55cv qui 57 come mai?

[@TheKniperlight]

Is that 57 wheel horse power or crank?

[@mushroomcloud1]

rear wheel.. You can see the rear wheel spinning the roller.

[@TheKniperlight]

mushroomcloud1 You do understand that that this happens on every dyno right? The thing is that some tuners calculate the measured power + the driveshaft losses to get crankHP, and some just use the HP that's measured right at the wheel. I'm interested in which one of these two figures is mentioned here.

[@mushroomcloud1]

@@TheKniperlight When the manufacturers measure "crank" horsepower, they usually do so with the engine on a test stand and measure directly from the output shaft of the engine. I thought that was what you were referring to. My mistake.

[@TheKniperlight]

mushroomcloud1 np!

[@xorbe2]

Other published dyno results have put it at 51 whp and 48 ft-lbs.

[@pretpiloot]

forgot to tape it. next run after mods i will get it on tape