New! The correct way to flue your Stanley stove

To ensure your Stanley Stove operates at optimum efficiency, it is essential that the chimney system to which the product is connected is capable of providing the minimum draught requirement for that particular product.

[@affinityfunable]

Just clean out about 30 ounces of ash from my 38' long liner. Stove works so much better. Might connect to outside air next time I service it.

[@charliegalanti8765]

Is it in your basement? I got a guy who says it's hard to get a stove to work with 38' of liner in a basement set up

[@ghezaltardesigndeco1175]

Thank you very simple and very useful.

[@conceptabogart3818]

Freak

[@s312a22s]

Removed a section in my camper where the entertainment area is and installed. Works great. Instead of propane furnace heat, I can use this kzbin.infoUgkxATHBlMJwipGgVWseuAFKvDQ_5R4_lywo to heat the camper as long as it's hooked up to shore power. Only thing I do not like is there does not seem to be a thermostat. I'm presuming it has a built-in one so it does not overheat. Really like all the other color options it has to offer.

[@pikifrino]

EXCELLENT!.. Thank you

[@sinankocak4147]

Thank you to share.

[@White_devil1980]

Can the stove/flu cleaning rods be used if the stove has a back 90 elbow that connects to the upright flu

[@mohdalkhasawneh3570]

I have 6 inch pipe from the wood stove while will go into 3 inch pipe flue to roof . is it possible to use a reducer

[@gloriadavey8024]

I don't have a chimney and would like to have a stove fitted as above, it's says that horizontal pipes are a maximum of six inches, but how long is the 45 degree bend?

[@alanhaze3192]

Is flue really necessary...can one route boiler outlet directly to existing chimney?

[@tonycullen8764]

Is there a Stanley fire front boiler stove or small stove like oisin that you can clean chimney flue through the front

[@Jean-vz8co]

The external metal chimney must be insulated for not have to much carbon in it!!!! (condensation/carbonisation)).. and the correct strong aspiration who need high temperature... then all very good... if the diameter of the pipes is to much the flux will be slow, it dépends the volume/power of fire/smokes.... By

[@tahjbo]

I have an older Stanley gas fire place - I just contacted service to determine if I can direct vent flu on the wall, is this possible or do I need to go directly through the roof as seen in some of the videos using an existing fireplace chimney? I plan to use a certified installer, I am simply gathering information for my certified installer, investigating, obtaining the parts to save time & money. Thank you for your time...

[@waterfordstanley3337]

Hi Tahj - This video is for solid fuel and wood burning stoves. I would contact our service department re your Stanley Gas Fire - [e-mail]

[@Pjp43]

Fabricated chimney does not need to clear apex.

[@hunterman600cc]

WHERE DO YOU FIND A 45 DEGREE THROUGH THE WALL!?! Everything I have seen has been 90 only! I'd like to go through at 45 for better draft.

[@somedude3601]

a 90 can be twisted to change the angle.

[@topoyillo9728]

En español por favor

[@eddjordan2399]

there is some true true but allso some non true true in this video

[@pixielowman2748]

what joke.......cant install a new chiminny or flu unless u buy a new stove.......worthless vid