Nissan Quashqai Front Brake Pads Replacement

[@mark6rs2k]

Absolutely shocking video, way to much copper slip, infact you don't need any. Worst part of the video is you have clearly put copper slip on the friction material aswell.

[@00Donkey00]

That seems like far too much copper grease.

[@stevenclark6910]

not just too much copper grease but the grease is on the main pads and the rotor, Hope this owner is able to brake ok...

[@paullock1026]

Thanks.Very handy.As a novice to vehicle maintenance I would like to know more about pushing pistons back.

[@jorgenbjork5740]

Copper grease will draw dust and other particles too it and you also got it on the frictionside of the pads. Very bad job....NO CARMANUFACTOR USE GREASE OUTSIDE BREAKES. ONLY DRY AND CLEAN PAINTED SURFACES THAT WILL NOT CLOGG UP

[@paulwood1689]

Good vid guys,is it the same procedure for a 2005 Note.

[@bill5067]

as someone said before in the comments. "Absolutely shocking video, way to much copper slip, infact you don't need any. Worst part of the video is you have clearly put copper slip on the friction material aswell"

[@pokerstars9167]

I have a 10 model qashqai the wing mirror on the drivers side will not fold in when I push the manual button the passenger one works fine .could you do a video on how to take apart a wing mirror and how to fix it thanks

[@RayProctorHerts]

Thanks chaps. Most useful.

[@MrMarcburger]

terrible. slapping copper grease all over the parts and noticing the brake oil level is over max you just screw the cap on. bloody hell..

[@majkelandzelo]

Way to much grease, using compressed air to clean the dust... NO.

[@LauDuKai]

Hi, what did you torque the caliper bolts to?

[@ss4ushop]

Very helpful, thanks

[@hollypebbles]

Does that mean that it's o.k. for brake fluid to be OVER the max mark?

[@MrTheonlyhawk]

copper grease all over the inside of the pads between disc and pads at least clean it or bad breakes .

[@marcosantos283]

hi there which grease are you using ??????

[@karin6936]

COPPER GREASE TO STOP BRAKE SQWEAK

[@christos4632]

good video. nice done.tnx

[@RoeeBloch]

Hi, Is the Metal that you attached to the back of brakes is a part of the brakes pad ? or part that belong to the car ? I bought original pads and I don't have the metals ?

[@benjames2310]

Roee Bloch they are normally on pads but sometimes they rust and fall apart.

[@jimmy7484]

thanks guys i am old school nice to be able to see what tools are needed

[@tomasz1964]

Copper grease! Maybe you should research GALVANIC CORROSION. Your welcome.

[@richardjones9125]

dont need grease as it has metal plates, grease on the material, use brake cleaner to clean the points of contact. How not to install pads, bad job guys, seriously

[@thomasmccarthy4920]

Awful

[@eslater5219]

Very helpful, many thanks