Nissan Xterra Replacement Remote Programming 2000 2010

Visit us at www.carandtruck...
PLEASE READ CAREFULLY BEFORE TRYING! IF AT ANY TIME YOU MAKE A MISTAKE, START AND STOP YOUR CAR, EXIT THE VEHICLE AND START OVER. THE REMOTE CAN BE ONLY PROGRAMMED WITH A MASTER KEY
1.SIT IN XTERRA CAR WITH DOORS AND WINDOWS CLOSED.
2.LOCK XTERRA DOORS WITH POWER DOOR LOCK SWITCH ON DRIVER'S DOOR.
3.PUT IN AND PULL OUT XTERRA KEY FROM IGNITION APPROX. 8 TIMES OR UNTIL YOU SEE THE HAZARD/TURN SIGNAL LIGHTS FLASH.(older models lights may flash after 4 or 5 times) YOU NEED TO DO THAT IN LESS THEN 10 SEC
4.WHEN XTERRA HAZARD LIGHTS FLASH (ON 2005 AND NEWER MODELS THE GAUGE NEEDLES MAY JUMP A LITTLE INSTEAD) , PUT KEY IN IGNITION AND TURN TO THE ACC POSITION.(when your hazard lights flash your car is sending a signal to be received by the remote)
5.PRESS LOCK BUTTON ON THE NEW XTERRA REMOTE TRANSMITTER, LIGHTS SHOULD FLASH AGAIN.
IF YOU HAVE 2 REMOTES, 1 NEW AND 1 OLD OR 2 NEW ONES, PLEASE CONTINUE WITH STEPS 6 AND 7. IF NOT, SKIP TO END.
6.PRESS XTERRA UNLOCK BUTTON ON DRIVER'S DOOR, THEN LOCK BUTTON ON DRIVERS DOOR, LIGHTS WILL AGAIN FLASH
7.PRESS LOCK BUTTON ON 2ND NEW OR OLD REMOTE. LIGHTS AGAIN WILL FLASH.
YOU ARE DONE. EXIT VEHICLE AND TRY YOUR REMOTE. IT WILL NOT WORK FROM INSIDE CAR OR WITH KEY IN IGNITION.
Note: if your hazard lights flash after inserting your key in and out, but you can't get the remote to program, you may have a dead battery or the wrong remote. If instructions do not work, do it again but when you get in - shut the door, buckle seat belt and lock doors, then proceed to putting key in ignition

[@hopshoffa86]

Dude, Thanks a bunch!! I did this in less than 10 minutes and both fey fobs are working. I had to do the same steps for the 2nd as the 1st instead of just hitting unlock but it was super easy.

[@andrewgreiner1380]

Thank you have a 02 supercharged. Saved me a lot of time and hassle you rock man

[@rodrunner4143]

Hi, my nissan tiida, japanese version of versa doesn’t work. It just only unlock the doors every time i do the inserting of the key at 6th times. Any solution to that? Thanks

[@Tony-uo4ml]

What difference does it make if the windows are closed?

[@MehdiExplorer]

What if some other guy presses his key fob trying to open or lock his car, at the same time the transmitter is ready for the signal?

[@JohnJohn-ke9nh]

Thank you Thank you Thank you,,, seeing it is better than reading the instruction.

[@ChibiCookiexX]

omgeee thank you so much! :D this help me out so quick!

[@michaeltrout6179]

Can i install an aftermarket ignition and how is it done

[@MYKEYSAUTOMOTIVE]

Your sticking the key too fast thats why ...you have to do it slow, 6 times, each time per second.