Pin code reading golf mk5 instrument cluster on the bench no need to strip or soldering required

[@train4905]

I really enjoyed that sir,very informative😊

[@caralarmandradio]

Glad you enjoyed it!

[@v.juanhierro4493]

Golf video. I have a golf v december 2006 with dash 1k0820873B. I try to extract pin with vag k Commander 1.4 and doesnt work..Do you know if this vag pin reader Will works for me?

[@caralarmandradio]

Vag key login at the moment is the most successful unit for pulling a pin without spending a fortune

[@MichaelEleftheriou-pp7hx]

Hello Mark, I have been watching some of your videos and find them very interesting but I wanted some advice with a polo 2011 1.4, I need to swap out the engine ECU with a used unit what would be the procedure, I have IM608 and the other tools you show in the videos but not done any thing like this before if you could help me, please.

[@caralarmandradio]

Yes email me your reg number please [e-mail]

[@mattmccaslin6681]

You mentioned K wire but on 2008 mk5 I didn’t think there was a K wire. In that area it seems there are 4 CAN wires. Do you have the pinout you used? Thanks very much

[@caralarmandradio]

Send me an email to [e-mail] and i will forward a pinout but to clarify there are two can wires and we dont use the k line for pincode reading

[@1121756]

Hi! Does it work on a seat Ibiza 2011 tdi if I remove ecu and try to use obd2 port to read cluster pin? Thanks

[@caralarmandradio]

Yes it might try it and let us know

[@prawny12009]

Is k the one labelled, Dash panel CAN screening" or they one labelled "dash panel CAN wake up"

[@caralarmandradio]

Hi the wake up is on pin 15 k line

[@theemrroboto]

I have a 2008 Golf V. Have you used this on that year of golf? I hear that 2008 could cause some trouble due to the immo 4 system. Also, where did you purchase from?

[@caralarmandradio]

Yes it works well pulls the pin in seconds and you can still get them on ebay if not alli express

[@KennySpark8574]

How did you get the lcd display to light up? I have the same cluster here, I have connected live ignition and ground, the clocks turn on but the lcd display doesn't show any data (milage ect) Is this something the go diag does? Thanks

[@caralarmandradio]

Hi kenny pins 1 and 2 live pin 19 earth and it should light up

[@chrisd9010]

I did the Same thing you did but as soon as i Fire up the Instrument cluster it Shows SAFE. I think you can‘t read the pin Code as Long as it Shows SAFE. Is there any way for it to not go into this Mode?

[@caralarmandradio]

Hi Chris i have had no issues with reading pins when it says safe. It says safe when it is not matched to the ecu

[@Cristian-lk2iu]

Hello,you can help me to wire my instrument cluster?i want to check only the dashboard light.thx

[@caralarmandradio]

Send me an email and i will send across the pin outs for you [e-mail]

[@ascending74]

Do you remember the serial number to that cluster? Mine isnt pulling the pin code

[@caralarmandradio]

No sorry

[@nubetubeme]

hi could you connect the vag pin code rear to the clocks without using the go diag

[@caralarmandradio]

No you need an interface of some kind