Polaris RZR Ball Joint Replacement | 2015 RZR 900S | Partzilla.com

[@bearsgarage272]

Super helpful. I just realized my upper ball joint had some slop and this task looks easier than i anticipated. Thanks for making this video

[@PaulyVonPaulson]

Man your shop is as clean as a hospital OR!! Great videos

[@PartzillaParts]

We make the interns clean everything with Qtips! (Jeez, I wish we had interns now.)

[@monsterelkguy]

Great video can you show a video on how to change the boot on the steering please. I have a 2015 Polaris ranger crew 900.

[@Garth357]

Great video! Could have put that front lower a-arm bolt back in from the rear. Might have saved ya some time next time. Lol

[@guspompa3283]

Berry nice like everything you do tks for the tips

[@wes10162122]

Great video. Well done.

[@GasnDirt84]

Great video!!

[@mikeconnors8184]

Have you ever used a manual hand held c-clamp style ball joint press?

[@tewminator]

I don't have a press. Is there a tool to remove ball joint on a 2014 RZR 900 xp without removing A arm?

[@shaywellman9319]

Does that go for the basic 800 trail to

[@AcidicJO]

Hey man I have a 2012 Rzr 800, I had A LOT of slop/play between the ball joint and the spindle. I’ve ordered replacement parts for both but I cannot find the exact pinch bolt I’m suppose to use. Do you have a part number or the exact size or anything that can help. Any info is appreciated thank you !

[@PartzillaParts]

Here is the diagram for the front arms. Not sure which bolt you are referring to. www.partzilla.com/catalog/polaris/side-by-side/2012/rzr-800-efi-eps-r12vh76ab-ad-af-ah-ai-aj-am-eab-eas/suspension-front-control-arms

[@nolabrannen102]

i am rebuilding a Yamaha tt600 1983 and it has piston slap i measured the bore and its in speck and the piston is too, there is not any bent con rods but the bottom end bearing arnt the best what can i do?

[@PartzillaParts]

Basic rule of thumb, if you're already in the area, replace the bearings, no reason not to if they "aren't the best."

[@SoutheastHVAC]

None of this went near as smooth as it did in this video

[@gamerfreek1691]

Mine aren’t just sliding back into place like that.... PLEASE HELP!!!!!

[@PartzillaParts]

Are you pressing them in?