Hi, Greetings from Western Australia. Great Video. Why not use a easily available 1k ohm resister instead of 987 ohm? Is the size critical? And what is the wattage of the resistor please?
@LucasSteyn Жыл бұрын
I measured the resistance of the stock sensor and used a matching value resistor so that the cars computer don’t pick up a fault
@yaronr34472 жыл бұрын
Hi, Good work man 👨 Does it disable the trc only? Or it disabled ABS as well?
@The_Touring_Jedi2 жыл бұрын
336.000km and still runing strong...woow. I wonder how 4.0 V6 performs in compare to diesel.
@francisbenyah44892 жыл бұрын
345.000km still going strong
@dietershobbypakanal3 жыл бұрын
I mean the A Trac is off if the central lock is activ 🤔 but i do a other way , i used the purple wire and connect to ground , so i have one switch to turn off A trac and ABS , you see it in the Display but if i switch back no failure and i can drive too to switch back 😊
@cezaryczaro54292 жыл бұрын
Thanks for this movie! btw - not sure if you noticed - but you have a baby or something under the hood
@basheratamna76843 жыл бұрын
hello I would like to thank you for the perfect video and your explanation but i have some questions about the technique ! 1.Is it safe for the abs unit? 2.you used resistor 987 ohm to disconnect ,but when you measerment the sensor you wrote 1982 ohm ! Isn’t it should be the same number ? I’m trying to figure it out which number of resistor should i have for my parado 120 year 2004..
@LucasSteyn3 жыл бұрын
Hi, the resistance in the sensor is just so the computer know there is a sensor, if its open circiut/ short circiut then you get a fault code. So i wired my hack and when its connected it closes the circiut with a resistor downstream.
@basheratamna76843 жыл бұрын
@@LucasSteyn thank you 🙂 u can help me with thise qust.? you used resistor 987 ohm to disconnect ,but when you measerment the sensor you wrote 1982 ohm ! Isn’t it should be the same number ? I’m trying to figure it out which number of resistor should i have for my parado 120 year 2004.. 🙂🙂🙂
@LucasSteyn3 жыл бұрын
Hi, to test if it works before you start cutting wires jest unplug the sensor and do a sand/mud drive to see if the antispin still kicks inn, you will get a faut display light but it will go away once you plug it back in.