PRINSU INSTALL: Chevy Colorado Roof Rack

[@1smokan]

Help, my wind deflector rubber seal is not touching the roof of the truck and is up off the surface by about a quarter inch. Is there any adjustment to slide it down lower? I have hissing noise coming from it as a result I believe?

[@johnfernandez2101]

Will this work with the Yakima roof tracks?

[@nathanwright1031]

Yes it will.

[@Merkicko]

Can this roof rack would fit the 1st gen Colorado?

[@nathanwright1031]

As far as we know they are enough different that a perfect fit will not be achieved. That being said we have some customers that have put them on anyway and made them work the best they can.

[@dylanneuman4629]

Will this rack fit the 2023 colorado?

[@nathanwright1031]

We haven't made an official announcement yet but YES, it will!

[@rt4wd_wolff]

Did you vacuum the shavings out that fell on the headliner?

[@CBIOFFROADFAB]

Yes as part of a good installation we always clean up the installation area of all drilling debris. If you have any questions on the install please let us know!

[@rt4wd_wolff]

@@CBIOFFROADFAB just ordered mine yesterday. What kind of silicone do you recommend to seal the holes?

[@LowNSlowIII]

​@@rt4wd_wolffblack rtv silicone is what the video says...

[@rt4wd_wolff]

@@LowNSlowIII what are you talking about...???

[@UpNorthMotorsports]

Would kc hilights gravity leds light bar fit on the rack?

[@nathanwright1031]

Yes they will!

[@jmcastaneda1974]

shouldn't have been better to drill the weatherstripping to the size of the bushing? since the foot of the rack does not make contact with the roof, and you cut the weatherstripping for no good reason, and just added cheap double-sided tape... maybe next time, use a step bit, mark the hole and slowly drill the weatherstrip until the bushing fit, that way the pins that hold it still work. just my .02 cents

[@Ajs3371]

It's likely that the spacers are almost the width of the weatherstripping so you'd probably barely leave any material on the actual weatherstripping where the holes are, and it's likely you'd be slightly off in the alignment so it's better to just cut it

[@justinhenderson2708]

Drilling theu this roof is a pain in the ass