Project SC - Episode 11 (Turbo LS Swapped SC400)

[@dariusdarrell4334]

This beat resembles early Tpain ❤❤❤🤩🤩🤩🤩

[@davidgoldman8812]

FINALLY! Engine is in!

[@BradPalone]

I am in the process of doing this same swap…Where did you get the passenger side alternator bracket, and power steering pump, and bracket?

[@BrokeEF]

I used all ICT billet brackets. I think I have another new set actually. It uses truck spacing crank pulley, truck alternator, and then an f-body water pump and power steering pump.

[@bryansenulis7242]

So u ran the factory oil pan..it clears the hood? I have a extra shell was going to flip but may do LS.

[@BrokeEF]

I do not have a factory pan, but the stock f-body pan is the best option really. I tried a few, and should have just done that one LOL Also, yes it clears the stock hood no problem with the LS6 intake. I havent measured to see how much room there is, but I would guess any of the car intakes would be no issue.

[@vicentevasquez5458]

Do you have link or where to get the Motor mounts ?

[@alvarozermeno3557]

where did you get your motor mounts from??

[@BrokeEF]

I got them from Dan Perlenfein

[@thatguy-wo7cd]

Off Facebook? Also what oil pan did you use, your engine sits nicely and not super tall

[@BrokeEF]

@@thatguy-wo7cd Yep, off FB. I am using a knock off Holley pan, but I would probably use an F-body pan if I did it again.