Protocol Neo Drone Controller repair!

[@slobacarfree]

I enjoyed watching you solder the smd component. Good job, I thought that you won't make it to work again :)

[@simhalegend8283]

Nice video about transmitter repair, I have a problem my drone led lights not become solid after binding with transmitter, and also motors not rotating, where is the problem in the transmitter or in receiver, if it how to repair, if in transmitter how to check and repair it could you help me

[@markoni985]

Hi, as far as I understand the transmitter tries to bind after you turn it on and move the throttle stick. The led on it will become solid even if the drone is not turned on and you perform that sequence. It is not easy to determine where is fault without some specialized equipment (oscilloscope and SDR radio). You can try to put both transmitter and the drone really close to each other. Also make sure the transmitter has a fresh set of batteries and the drone battery is charged. Drop-off can occur if the voltage is to low. Measure voltage of the drone battery after charging it should be above 4V. If it's not it probably needs a replacement, and it's causing connection problems.

[@snipergaming5653]

My also same problem but I have given the same volt battery with fresh battery after that also it not working

[@snipergaming5653]

@@markoni985 pls.tell

[@diamondfamilychannel3014]

mera drone bind nhi hota or remote ka function ki beep ki awaz sunae dete hai light stable hua bagair remote ki

[@sayedsaber9543]

Yaar bhai mera dron ka remot change hogaya hai use kaise chalaou please help mee

[@WjTp]

What is the big green thing u took off I need the name