bobcat 773 park brake fix

[@scottbennett8018]

Thx for the share. - I have the same problem. You could just put a timer in hooked to the starter motor btw to make things easy for yourself. - or just put it direct to the starter solenoid might be even simpler. (The white wire) You explained the mystery of what wire does what very well.

[@billsbazarbuilds4299]

thank you great video you explained it very well unlike the others i watched

[@CoyoteChris]

So did you put 12volt a to the hold switch? Which feeds the red wire.

[@CoyoteChris]

When you tested the solenoid how did you go about it? When I tried to test it I put a ground to the ground wire and then I put 12 volts to the white wire but nothing happened. Please if you can HELP!

[@stephenr0500]

You could rewire the hold switch to the lapbar so everytime you lift up, it would drop the parking brake to stop the machine from rolling forward. Basically what Bobcat has Wired originally

[@punkinhed81]

There was trouble with that. That's why I bypassed it.

[@stephenr0500]

@@punkinhed81 run a new switch in place of the old one, this way you don't have to reset it everytime you exit the machine

[@punkinhed81]

Only have to reset it when I turn off machine and start it up. Once I start it I just bump the button once

[@anchorbrandranch]

I’m fighting with the park brake stuck on on my cat247b I’ve been looking at everything on the internet and found your video now I’m thinking of trying what you did. My solenoid has a yellow and white. How can I tell for sure which wire does what?

[@justatool]

What type of switches are the 2 switches, and does the white wire go to the green?

[@635suz7]

That should work for my t190. Are you running 12v to the white wire ? I only have 5 volts out of the controller to my red wire pretty sure that’s why it doesn’t work.

[@steveberlozan6026]

Hey do you have a diagram of your set up no sure of how the white wire go thank you for any help

[@mattstarzec4143]

Hey Guy, I have some questions about the strip tiller you made years ago. How do I get in touch to ask you some questions?

[@ahmadalwdani57]

Hi, I have a jcb skid steer loader 135 it doesn't move and the park break doesn't release Can you help me with this problem please

[@mikelumaj8802]

I’m having the same issue Where did you connect the hold wire ? Thank you

[@punkinhed81]

Ran new switches to the wires

[@mikelumaj8802]

@@punkinhed81 thank you so much, great video

[@punkinhed81]

Watch it a few times. I think I covered it all.

[@meansq]

Hi, Where did you get that switch, link or model number? Does it send a pulse to pull it up?

[@punkinhed81]

Just regular switchs at napa. I leave toggle on all the time when running it powers the low side that holds it off. Its off and on with key. So when i first start it i have to hit button to suck the rod up to disengage brake. Then if its running and i want to put brake on i shut off toggle and pin drops down.

[@steveberlozan6026]

@@punkinhed81 can you. please send me a diagram of your set up thank you

[@Max-sh7wf]

What if I completely lost switch power?

[@neivarvelez2961]

Gracias desde Colombia me sirvió vastanre

[@RDBDallas]

Well, I have a 763 BC and it's doing the same thing as yours :{