Video highlighting the swap of a loud rear axle bearing in a Jeep rear axle Follow us on Instagram: / freakin_jeep_and_toys_...
Пікірлер: 16
@strayhound61 Жыл бұрын
Thank you! Finally, a real mechanic!! I've pounded outer races in and out of the hubs on my 1961 Greyhound bus with a chisel just like you did here. Everyone says you have to have a press. I'm sure glad your's wasn't working for this video. Now I'm going to back what I learned years ago. Thanks for a good instructional video.
@FreakinJeepGarage Жыл бұрын
I'm old school. I appreciate the feedback.
@williamjoseph987 ай бұрын
This video REALLY helped me out, I didnt have a press. Thanks
@jerrywhalen21003 жыл бұрын
I'm so surprised to see you using hand tools when everybody else has to have a press you make it look easy
@FreakinJeepGarage2 жыл бұрын
Many people don't have a press or a shop full of tools. I wanted to show how it's done with a basic set of tools
@raybutlerjr81902 жыл бұрын
Excellent.
@BIGLENCHO19693 жыл бұрын
Great job, maybe i can get the time to do this on mine
@estoneback50222 жыл бұрын
Explain how a dana 35 or 44a aka 44hd use tapered wheel bearings, I have both in my yard and they use the cheap axle wear out flat rollers
@FreakinJeepGarage2 жыл бұрын
I'm not sure what you are asking.
@atozproductions96602 жыл бұрын
That's what they just sold me at O'Reilly's too I was wondering the same damn thing cuz I was looking for tapered too. it says tapered on the national but they're flat as can be
@austinjackson96502 жыл бұрын
I did thos job on a 2001 cherokee. Dana 35. Afterwards I noticed that the axle has some play, in and out. Is that a bad axle retainer? Is it OK to have a little play? It's about 1/16 inch or less
@FreakinJeepGarage8 ай бұрын
It's not uncommon, but that could be a sign of other worn components. Not ideal for bearings longevity either. Good luck.
@Mr383chevyboy7 күн бұрын
Id rather press them on way faster and not gonna chew the bearing or retainer up
@FreakinJeepGarage6 күн бұрын
@@Mr383chevyboy I normally press them off and on, but not everyone has a press in their garage like we do at the auto repair shop. I was showing that it can be done.
@johnswanson37418 ай бұрын
Inferior OEM parts that did not hold up very well....Chinese bearings and seals from the factory! Who makes these corporate decisions to save a few pennies on parts, and cause all the pain to the consumer in the future?
@FreakinJeepGarage8 ай бұрын
I'm not sure what you are getting at. I hope the video helped you with your project though