RDQ Bardwell F7 Add Model & Bind with R XSR Receiver

[@BKD70]

Hey Steve, great video. I just bought all the stuff to build a quad, namely the Xilo Phreakstyle JB edition bundle. Anyway, I've bought the RM TX16S transmitter, and a FrSky RXSR receiver. I've read a lot about how this receiver will not bind to the RM if the receiver has the 2.0 or 2.1 firmware... but they are all older videos from 2019ish. Has this issue been resolved, or will I need to flash the RXSR back to firmware 1.9? I can't find any new information on this it seems. I just discovered your channel and subbed! Tonight I'll start binge watching your playlist on the RMTX16S... Open TX is totally new to me as an old Futaba and HiTec guy. Thanks again for all this information!

[@diggindiggenit6540]

Amazing stuff, I just acquired a drone but pretty sure I don't have the items needed to run it. it's a phantom 3 dji never used, it might be older technology now.

[@TahoeSteve]

Your phantom should be much easier to fly. it's a consumer drone whereas this video is about building a hobby drone pretty much from scratch. I think DJI has propriatary software you can use, perhaps this? www.dji.com/downloads/products/phantom-3-standard Have fun with it!

[@diggindiggenit6540]

​@@TahoeSteve I think you have to have a cell phone or i pad device to operate it, good luck with your drone

[@slosolo2]

Came by to see if you had any comments on the FBI investigation into drones in the CLT landing pattern.

[@TahoeSteve]

As a hobbyist who has been building, configuring, flying, crashing and rebuilding UAVs for almost 10 years, this kind of stuff boils me to the core. If the allegations are true, I hope they catch whoever it was. It's uneducated, ridiculous behavior like this that will end the hobby for everyone.