Replace rear Dana 44 axle seal/bearing Jeep Wrangler jk Rubicon

[@kirklaplace5013]

I was thinking about the come along trick and I see you used it, my axle is out so I get to really go western with it, thanks for the video.

[@Whiteandsonsgarage]

Great video mate, I should probably do the ones on my tj

[@LivingOffroadLife]

Thank you! TJs are easy as well just have to pull center pin and c-clip

[@blackbiker1961]

I'm not the only one who had a problem trying to remove the axle shaft my left rear is stuck I still haven't found a way to get it out.

[@LivingOffroadLife]

You can do like we did. I've never had one that was a stuck as the one in this video. Put a chain around the hub with a come-along then put a little bit of pressure and smack the hub.

[@blackbiker1961]

@@LivingOffroadLife This might be my next step

[@LivingOffroadLife]

Good luck 👍 hoping for the Best.

[@kurtw356]

so I take nothing like a clip on the inside of the gear set needs removed?...even on the rubicon with a locker?....I'm pulling mine apart to see if the left shaft tube is bent from a wreck Thanks for the video it helps

[@LivingOffroadLife]

If it's a 44 there is no c clip. Rubicons came with the Dana 44 so you just take the four bolts off the back of the hub and you pop it out usually easier than what was in this video. A slide Hammer does work great though usually.

[@terryanderson7957]

I have the tell tail sign of an axle leak. Just not looking forward to more work!

[@kurtw356]

oh and cant you just replace the seals with out having to cut the bearings up, thanks again

[@LivingOffroadLife]

Unfortunately there is no way to replace the seal without pulling the bearing. They sell a kit with the bearing and the seal or you can just buy the bearing and the seal separate.