Replace Side Mirror 🪞 Chrysler 300 Dodge Magnum Dodge Charger

Easily see how to remove and install a side mirror 🪞 or wing mirror for a Chrysler 300 or Dodge Magnum or Charger. This is the most efficient way without removing the inner door panel completely or the exterior chrome door trim. Please LIKE 👍👍👍 & SUBSCRIBE 🔔 if this video helps. Click on SHOW MORE to see all tools needed. 👉
⚠️⚠️⚠️ Be careful when removing the clips from the inner door panel. Do it lightly. You could pull the inner door panel off completely leaving the clips on, but it might not feel as tight when you line the door panel back on. This is why I removed the clips.
Tools 🧰 needed:
Ratchet wrench 🔧
8 mm socket
Pry bar
Phillips screwdriver
Flat tip screwdrivers ( a few of them)
Pointed tip like a hook pick
Torx T25 bit
If this video helped you please LIKE 👍👍👍 AND SUBSCRIBE 🔔 and/or make videos you think may help others.
Or you can help support this channel and get me a cup of coffee here ☕:
➡️www.buymeacoffee.com/randomca...
OR
➡️ ko-fi.com/fixcaryourself
#fixcaryourself
👍 & 🔔

[@stevenalvarez3632]

Thanks man

[@FixCarYourself]

np

[@_wimza_7983]

Hey man thanks for the content. Can i just ask, do you think its likely the memory module or the wing mirror itself that doesnt allow me to adjust the mirror in the left direction? My memory seats dont work properly either, two separate issues? Cheers man 300c crd 3.0 v6

[@FixCarYourself]

Hard to say. It could be a bad wire in the doors wire harness, it could be the power door module that needs to be replaced inside the door (which would be my 1st guess). Possibly removing the battery terminals, or even resetting the memory seats.

[@FixCarYourself]

Not sure how much time or money your looking to spend for a new power door module, but here is a video on removing it: kzbin.info/www/bejne/jYmQqoSrq9mFqq8

[@_wimza_7983]

@@FixCarYourself i cant seem to get into that door loom its a bastard, is there a nack? Very much appreciate the response man

[@FixCarYourself]

@@_wimza_7983By door loom, I assume you mean the rubber boot on the side of the car or lower A pillar area. You will want to use either your fingers, a pry bar, or pliers to pull back the rubber boot, and inspect for a broken wire. You do not need to remove the actual white connector piece. Here is a video of removing it. Watch the 1st 3 minutes. kzbin.info/www/bejne/mKCth6eHYsh1bs0

[@_wimza_7983]

@@FixCarYourself you are a legend sir. Thank you x