Peugeot 308 Cat S Copart UK Salvage Rebuild Part 3

Hello and welcome
This episode on the Peugeot 308 Cat S Copart UK Salvage Rebuild Part 3 i push out the back damage panel and crash bar

[@frankyates7910]

a good result ,well done.

[@donelsley7519]

Use your spot welder tabs on the outside panel and gently pull with the forklift again.

[@waynerountree9284]

Great progress on the car so far top job thanks for sharing 👍👍

[@rayoscroft3775]

I'm sure that there is a possibility you will get this process done unbeatable you are😊

[@petar443]

You can use different assortment of pry bars on the inside through the holes to support and put pressure on the low areas while hitting with a hammer on the front side on the peaks. Use a wood blocks and hit them with a hammer not to scratch the paint. You can also use the stud welder to make it perfect , but then you must prime and paint. Weld a stud , and grab it with a vise grips , and modify the vise grips by welding a hook on the vise grip handle, then you can use the come-along and the forklift to pull while hammering on the high spots. Check the progress with a straightedge.

[@ResurwreckAutosUK]

@@petar443 thanks mate appreciate the info 👍👍

[@markopolo9559]

Maybe you can weld bits from you're pulling kit on the outside of the panel to pull it out with your hand winch tool?

[@normanstephens5391]

Well done Mark. See you in the next one. 👍👍

[@johnchincotta1qwdb15]

Hi Mark ,you are very versatile,nice job

[@Mr_DATA828]

Haha yeah hes like Mac giver haha

[@eddieMurphy11111]

nice job being done ,thanks for the video

[@Mr_DATA828]

Your pretty handy using the fork lift mark, sainsburys in benfleet are looking for enthusiastic operators lol 😂😂

[@Mr_DATA828]

NAIL they've asking me to high stack this pallets of apples upon each other but let's do this haha 😅

[@rickwilliams1505]

Great job , don't brake your leg at sports day

[@Mr_DATA828]

Not better to replace the rear crash bar rather than bend

[@ResurwreckAutosUK]

@@Mr_DATA828 hi mate I did change the crash bar I pulled the bent one out because it helped with the end plates