Review BHJ Cam Bearing Installer vs Kent Moore Harbor Frieght Aluminum Block LS Shelby American RPM

[@loganpenland6568]

I saw this tool a good while back cant afford it so i built my own using acme threaded rod couple trunion thrust bearings and only ordered the correct bearing puck made a thandle for the acme nut and pull them right in.

[@brianb5779]

Learned somthing, thanks

[@edpetrocelli2633]

I finally wore out my durabond bearing tool, replacement was $670. So I bought the one you have in the grey box......... couldn`t believe how easy it was to install bearings. So far for the last year I`ve had "0" trouble with it, every cam I put in turns with my little finger and it cost less than $200. I`ve not yet used it on rollers but I think it will work fine. BHJ stuff is so expensive, even their torque plates cost way more than most.

[@ProjectsMB]

@edpetrocelli2633 I used the Snapon version of the Kent Moore for decades too but it's not very good with LS blocks and that is the majority of my cam work now. This has cured that problem.

[@drcolster]

So someone else Bought it for you..???? $1500 or $2000... i can't seem to find a price on it...

[@ProjectsMB]

@@drcolster buy directly from BHJ Products.

[@mikefoley7561]

And didn’t even us the damn thing.😡

[@ProjectsMB]

@@mikefoley7561 there's a Part 2