Ball Joint Replacement: Citroen Relay Fiat Ducato Peugeot Boxer Ram Promaster Van

[@kevinpalmer7452]

Haven’t seen a ball joint that badly worn in years it must have been knocking and banging for a good while good job that you got to it in time a decent sized pot hole and that would have failed

[@guywilson2919]

Nice to see you using torque settings.

[@steveprice1014]

Great video...very informative. Can you tell me what impact wrench you use please.

[@jackrussellrambo5547]

Think the ballpoint is gone in my mazda 5 I've also got a lower booth an seal that's got to get done. Good vid again really enjoyin these tonight with tea and biscuits. #SUPERTECH

[@Jack_JJS]

46mm hub nut

[@sivy8611]

On mine it's not more like 50mm

[@edi8656]

Nice work 👍

[@Bgal-zx9hx]

I think those things with the holes in the middle and flat bits on them are nuts not bolts..😁😁

[@christopheralan8630]

Good video thanks 👍👍

[@AutoMotohowto46]

do you think I would have any chance of getting away with the drive shaft in its place without loosening the nut?

[@jasperbarlow2582]

Couldn,t on mine, the hub needed to come out too far, you will need a 42 mm socket( preferably a strong impact type) as the nut is torqued really high.

[@offshoretomorrow3346]

You could just jack the strut up to remove those bolts, I believe.

[@chrisshave7129]

Does wheel alignment need doing after replacing ball joint? There must be some adjustment in the positioning of the 3 hole plate to the hub?

[@OneManEngineering]

Not necessary, no. The position wont change after replacing the ball joint. You do however when replacing bearings/hubs etc. Greg

[@DaveGreeneramblingcarpenter]

Excellent video, just found both worn by mot guy 😂

[@ORileysAutos]

Oh no!

[@DaveGreeneramblingcarpenter]

@@ORileysAutos 😂😂 thought id done well getting the traction control/steering angle sensor sorted

[@shanec.7105]

I imagine those are prelubed for life?

[@christophberenotto]

The Moog brand is, other models require grease every 50,000

[@mikeholler514]

really annoying wind noise,

[@samcabodi]

really unhelpful comment,

[@mikeholler514]

@@samcabodi Why? Your content is worth criticizing. If it was crap, I would have ignored it. You have a talent worth polishing.