Rough Country 2.2 Dual steering stabilizer installation THE EASY WAY (

[@ocotillooutlaws4101]

Per request here are the torque specs for the bolts in this kit 3/8" 10ft/lbs-15ft/lbs 1/2" 40ft/lbs- 45ft/lbs

[@TrueNomadSkies]

It's funny how everyone says you need to remove your tie rod or cut the old fastener when you were able to wiggle it out. Thank you so much for making this video.

[@ocotillooutlaws4101]

Sometimes you’ve just gotta work smarter not harder 🤣 thanks so much for taking the time to comment and watch! I hope you found it useful 👍🏻

[@mrhermitoable]

That's a great video. You should remind us what torque measurement to do on the different brackets and such in case anybody is doing it without the installation manual.

[@ocotillooutlaws4101]

Thanks for checking it out and commenting! I hope you found it useful or pass it along to someone doing the same project. I was hesitant to share the torque specs because the give a range and didn't want to make it confusing. Since you asked here they are! 3/8" 10ft/lbs-15ft/lbs 1/2" 40ft/lbs- 45ft/lbs

[@anthonyhowell1568]

This was quite possibly the best video on KZbin on this install. Thank you so very much

[@ocotillooutlaws4101]

That's great to hear! Thanks so much for taking the time to comment, it really means a lot to me to know that someone maybe found it helpful and or useful in some way.

[@bajalife4ever]

Sounds like ASMR offroad 😂

[@ocotillooutlaws4101]

@@bajalife4ever It’s the calm and relaxing way to work on your jeep! 🤣🤣 Thanks for checking it out..

[@daleboseleyjr2800]

Did you have to get an alignment afterwards ?

[@ocotillooutlaws4101]

@@daleboseleyjr2800 Thanks for the question! It’s always a good idea to get an alignment after making any changes. Because I did not remove the tire or the tie rod and the vehicle sat on the ground the entire time I waited until I rotated my tires a few months later. If I had dismantled everything taken the tire off and removed the tie rod, I would have aligned it immediately. They checked it out at the time of tire rotation and it was still in specs! Hope this helps 😎 thanks for watching and taking the time to comment. 👍🏻

[@88rushrocks]

Actually it was very helpful and the best part was that it was easy lol

[@ocotillooutlaws4101]

@@88rushrocks Thanks for checking it out! I’m stoked you found it useful! 🤙🏻

[@MrCheerbo]

Hi to install your stablelizer is your suspension on stocks

[@ocotillooutlaws4101]

@@MrCheerbo Three inch lift with Procomp shocks stock tie rod.

[@MrCheerbo]

@@ocotillooutlaws4101 thanks

[@loganmarsh3584]

Did you jack up your Jeep?

[@ocotillooutlaws4101]

No, did everything on the ground without removing the tire or tie rod.

[@loganmarsh3584]

@@ocotillooutlaws4101 thanks for the quick reply, just finished. Best video I’ve found by far

[@ocotillooutlaws4101]

@@loganmarsh3584 Awesome!! Thanks for your comment and sharing! 😎