SENA 20S Schuberth C3P Installation

[@jameskelly4494]

Great video. Thanks for taking the time. So far I left the boom mic on and no problem yet. Figure I will be going through this again if the new Sena 50 gets HD branded. Wish they would have left the spec alone so you could use any headset and mic.

[@jessicaolson3565]

Used this guide to install the 20S into my C3 Pro Women's - worked perfectly! So glad to be able to mount it with the clamp rather than the iffy adhesive mount. Thanks a bunch! One thing to note - The piece of the clamp that presses against the outside of the helmet wont sit flat by default. However, I was able to get it to sit flat by adding the thin spacer. Issue and fix is described here (although I only had to add the thinner of the two spacers, not both): support.sena.com/hc/en-us/articles/214612866

[@ShuoZhang]

hi Jessica, this link is no longer available.

[@The63chicky]

Thanks so much!! Excellent instructions and glad I don't have to use the adhesive bracket as I don't trust that at all. Cheers from NZ :)

[@Richardrka1]

You are very welcome Ride Safe Richard RKA

[@ralfroth2964]

Great Video, Thanks. Did you use some rubber to thicken the clamp-rubber which goes inside the helmet?

[@Richardrka1]

No not needed

[@ralfroth2964]

Thank you

[@timhoke2]

Great video for the Sena 20S. I just bought the Sena 50S and have the Shuberth C3 Pro. Does the 50S install the same? THX

[@Richardrka1]

SAME .... Wish you would have purchased the 50 from us :-(

[@timhoke2]

@@Richardrka1 Sorry sir. I discovered you after the fact. But now I have your web page for future purchases. Your products look great. Thanks!

[@Richardrka1]

@@timhoke2 Had to POKE a little ;-) Ride safe

[@TheDfelan]

Thanks for the video. I have a sena 10r on my current lid that I want to switch to my new C3 lite. Should I not use the boom mic? Not finding much info for 10r install on a modular.

[@Richardrka1]

Need to use the boom mic on all modular helmets, The only difference is the main units way of attaching to the side of the helmet. Speakers same, boom mic same. Good luck ;-)

[@TheDfelan]

@@Richardrka1 thank you sir!

[@JpOcDenver]

Thanks!

[@hadowajp]

I noticed the 707 area code do you have a brick and mortar shop or is it online only Thanks in advance

[@Richardrka1]

Yes we do come by

[@maxk5134]

So half the installation?