Servicing The 1986 Kenmore 60 Series, Part 3 - Reassembly & Dry Test

Originally recorded September 29 & 30, 2023.
With the gasket for the transmission now fully cured, everything goes back in once and for all (until I have to take it apart again to replace the seals, 'nother series, 'nother time.)

[@MatthewJames-st5wv]

Keep the videos coming. Really enjoying your content

[@lizboz]

Thanks! Do plan to here now that I'm working my last week at my job.

[@MoneGetsIt]

How much was the fix, and how much did you get out of selling it?

[@lizboz]

Motor couplers were about $14 for a five pack of them, drain pump about $10 IIRC, transmission seal was $10, lid switch was $20-something, I bought it 7 years ago for my 92 Kenmore, but ended up using it here. Then the tub seals I had to replace later were about $80 altogether because the shaft seals came only as a kit with new bearings. So altogether, about $130-something. I think I then sold it for $100. Not a great profit that one, but needed to sell in any case to make room for other machines that will come and go.