SHARK IF250uk Taken apart, Remove bin, access motor, control board removal, Cordless vacuum cleaner

Please DONATE a small amount to help me improve and expand on future videos, at the moment I do not have enough subscribers so am hoping people will be kind in donating especially if it has helped and saved them money.
Either go on my home page to see the PayPal link or copy and paste the following to go to PayPals safe and secure donating page, thank you.
www.paypal.com/donate/?hosted... I'm no professional so video isn't the best but its just a guide to show the shark IF250uk being taken apart, it will show screw locations etc which you might be struggling to find.
This will be the same on the following models.
IF130ukth, IF200uk, IF200ukt, IF250ukt, IF250ukco, IF260ukth.

[@adamburton2165]

I am always reluctant to advise on tools needed because I’ve taken hundreds if not thousands of shark vacuum cleaners apart and the exact same model can have different size screws, but the basics are you need a torx bit with a hole in the end, common sizes used it T9, T10, T15 and T20, but the 2 screws inside the bin are usually a small cross headed type.

[@johannamcghee6063]

Thanks bought them

[@paulhendrick7640]

thanks for the video. is it a brushless motor? my one tries to start up but ultimately wont start.

[@lagunafishing]

Did you find out? Mine tries to start too but immediately cuts out.

[@johannamcghee6063]

What screw driver removes the screws does anyone know

[@christinemoore2253]

what screw driver did you use?

[@user-xb3mj7wg3x]

Hello how many screws should i be getting out of the bin please ?

[@salehnasr8356]

Excuse me sir, can you help me with my problem please tell me where can I buy a motor for shark vacuum model IF201 because water goes inside the motor and vacuum stop working

[@lagunafishing]

Mine tries to start but immediately cuts out. Any idea why and can it be fixed?

[@tonymarshall4353]

Check the continuity of the 3 wires that run through the wand. Mine has a break in continuity on one of the wires in the wand. The vacuum starts, speed goes very high and then stops with flashing lights on the vacuum head. I'm currently struggling to dismantle the wand.

[@adamburton2165]

To which part?

[@raheltefesetewold4046]

Is there a reverse video?

[@adamburton2165]

No at the time of making video I wasn’t interested in doing a reverse video, but at each stage you are struggling with if you pause the video it may help, regards

[@jefflbi]

I found this video very helpful in taking mine apart, but there is no way to clean the motor, and mine sounds like it's about to take off! It's gotten very loud. I'm afraid it's beyond fixing........

[@lagunafishing]

Did you throw it out or find a fix? Mine tries to start too but immediately cuts out.

[@jefflbi]

@@lagunafishing I tossed it. I would gladly buy another one since the batteries are still good, but they've changed the design and no longer use the same batteries.

[@lagunafishing]

@@jefflbi Yeah shame you can't buy these anymore. Wife bought a replacement battery for ours thinking that was the issue. However it must be something else as they are good. So far I've got it stripped down to expose the motor, now I'm wondering if the brushes might be worn or dust contamination deep inside. Thanks for responding anyway.

[@BeFearless_.1]

There's not enough screws!