Shark IF250uk Power Nozzle taken apart, Motor, Brush bar, Belt, Similar IF200uk, IF200ukt, IF250ukt

Please DONATE a small amount to help me improve and expand on future videos, at the moment I do not have enough subscribers so am hoping people will be kind in donating especially if it has helped and saved them money.
Either go on my home page to see the PayPal link or copy and paste the following to go to PayPals safe and secure donating page, thank you.
www.paypal.com/donate/?hosted... I am no professional, Just taken a shark IF250uk power nozzle apart, similar models are IF200uk, IF200ukt, IF250ukt, IF250ukco, IF260ukth although some minor differences, PCB access cover switch is different, some torx screws are different in size but its a good guide if you are not sure, it may help.

[@TimmyThoreson]

BRILLIANT!!!. The best and most informative strip down on youtube. Thanks.

[@captainbuggernut9565]

I've got an IF250 which cuts out after about 10 seconds the carpet/hard floor lights flash in unison and the power/max power flash in unison but each pair flash alternately to each other. I can immediately restart the vacuum and it will run for 10 seconds or so and then cut out again. It will run perfectly when the battery gets down to one charging bar. It also runs perfectly without the brushes going or with the power brush attachment. I have 3 batteries and it behaves like that with all three. Get to one bar of charge and its fine.

[@jamesgolynski2289]

Adam, I get the max power and extended runtime lights flashing one after the other when I try to power up this unit. I've stripped it down and cleaned everything. It's the if250uk model. Have you seen this fault before. When you hit power the motor pulses for a fraction of a second. Batteries all good, etc. Refuses to work. Any ideas? Thanks.