Shrinking a Dent on an Aluminum Panel! (PDR)

Check out how the Paintless Dent Removal method (PDR) is done on aluminum panels. Using traditional pdr tools you will see the damage being removed without going through a auto body shop. Check out the results!
Thanks for watching!

[@fernan2s136]

🔥🔥🔥

[@victorbarranca2910]

Nice result, did you use a sharp tool are a flat blade?

[@WipeOutPDR]

Used a flat blade from ultra Dent tools. Tried to have the heel just under the brace and pry off of that.

[@straightlines7432]

I wish you would have showed the tools you use and where you purchased them. Nice work btw

[@WipeOutPDR]

Sorry I didn't show what tool I used. It was a flat blade tool from ultra Dent tools. I tried using the bracing to pry off of with the heel of the tool.

[@straightlines7432]

@@WipeOutPDR ok thanks

[@straightlines7432]

Was that a single bend blade or a double bend blade ?

[@WipeOutPDR]

@@straightlines7432 It was a 36" tool with a 3" blade at 45 degree angle www.ultradenttools.com/collections/individual-tools/products/3809-36-bendable-twist-45-3-blade

[@twanaraoof6379]

Dopel Glas?

[@WipeOutPDR]

Yes it was. Always a little scary doing the dent down the window 😬