Subaru outback lift gate hatch support replacement removal explained

[@ronthornbury4971]

Following these good video instructions I installed two new tailgate struts on my 2010 Subaru Outback...easy!

[@magnets2flotsamjetsam840]

Thank you so much for this simple and easily visible video!

[@oscarsaravia8984]

You rock man thanks for the vid!

[@greyjay9202]

Short, sweet, simple. Good video.

[@pana013]

There's actually clips you can remove from each support unit. you don't need to remove brackets

[@cstockton5137]

Wish you would have shown how to put them back on

[@simpleauto3863]

Vice grips hold up one side while you align the other side. May have to push the hatch up a bit with your hand while adjusting. I used the screws to align the holes and lightly screwed them in for the sake of placement then used the impact for tightening.

[@marycharlton8903]

How did you use vice grips to hold it up? That is the part that is difficult.

[@simpleauto3863]

Clamp the vice grips on the lift arm that’s still attached while you replace the other one

[@andrewmcgowanthe4th]

can you show me the link? i can’t find the exact one you have in the video.